User's Manual
Table Of Contents
- Chapter 1 Getting Started
- Chapter 2 Operating Your Computer
- Using the Keyboard
- Using the Touchpad
- Using the Touchscreen (Optional)
- Using Network and Wireless Connections
- Using the Optical Disc Drive (Select Models Only)
- Using the Fingerprint Scanner (Optional)
- Using the RFID Reader (Optional)
- Chapter 3 Managing Power
- Chapter 4 Expanding Your Computer
- Chapter 5 Using BIOS Setup
- Chapter 6 Using Getac Software
- Chapter 7 Care and Maintenance
- Chapter 8 Troubleshooting
- Preliminary Checklist
- Solving Common Problems
- Battery Problems
- Bluetooth Problems
- Display Problems
- DVD Drive Problems
- Fingerprint Scanner Problems
- The following message appears during the fingerprint enrollment process – “Your device is having trouble recognizing you. Make sure your sensor is clean.”
- The following message appears during the fingerprint login process – “Couldn’t recognize that fingerprint. Make sure you’ve set up your fingerprint in Windows Hello.”
- Hardware Device Problems
- Hard Disk Drive Problems
- Keyboard and Touchpad Problems
- LAN Problems
- Power Management Problems
- Software Problems
- Sound Problems
- Startup Problems
- WLAN Problems
- Other Problems
- Resetting the Computer
- System Recovery
- Using the Driver Disc (Optional)
- Appendix A Specifications
- Appendix B Regulatory Information
33
Inserting and Removing a Disc
Follow this procedure to insert or remove a disc:
1. Turn on the computer.
2. Press the eject button and the DVD tray will slide out partially. Gently pull on it
until it is fully extended.
3. To insert a disc, place down the disc in the tray with its label facing up. Slightly
press the center of the disc until it clicks into place.
To remove a disc, hold the disc by its outer edge and lift it up from the tray.
4. Gently push the tray back into the drive.
NOTE: In the unlikely event that you are unable to release the drive tray by
pressing the eject button, you can manually release the disc. (See “DVD Drive
Problems” in Chapter 8.)
Eject button