User's Manual
Table Of Contents
- Chapter 1 Getting Started
- Chapter 2 Operating Your Computer
- Using the Keyboard
- Using the Touchpad
- Using the Touchscreen (Optional)
- Using Network and Wireless Connections
- Using the Optical Disc Drive (Select Models Only)
- Using the Fingerprint Scanner (Optional)
- Using the RFID Reader (Optional)
- Chapter 3 Managing Power
- Chapter 4 Expanding Your Computer
- Chapter 5 Using BIOS Setup
- Chapter 6 Using Getac Software
- Chapter 7 Care and Maintenance
- Chapter 8 Troubleshooting
- Preliminary Checklist
- Solving Common Problems
- Battery Problems
- Bluetooth Problems
- Display Problems
- DVD Drive Problems
- Fingerprint Scanner Problems
- The following message appears during the fingerprint enrollment process – “Your device is having trouble recognizing you. Make sure your sensor is clean.”
- The following message appears during the fingerprint login process – “Couldn’t recognize that fingerprint. Make sure you’ve set up your fingerprint in Windows Hello.”
- Hardware Device Problems
- Hard Disk Drive Problems
- Keyboard and Touchpad Problems
- LAN Problems
- Power Management Problems
- Software Problems
- Sound Problems
- Startup Problems
- WLAN Problems
- Other Problems
- Resetting the Computer
- System Recovery
- Using the Driver Disc (Optional)
- Appendix A Specifications
- Appendix B Regulatory Information
90
Canada
Canadian Department of Communications
Radio Interference Regulations Class B Compliance Notice
This Class B digital apparatus meets all requirements of the Canada
Interference-Causing equipment regulations.
Cet appareil numérique de Classe B respecte toutes les exigences du Règlement
Canadien sur le matériel brouileur.
This digital apparatus does not exceed the Class B limits for radio noise emissions
from digital apparatus set out in the Radio Interference Regulations of the
Canadian Department of Communications.
Le présent appareil numérique n’émet pas de bruits radioélectriques dépassant
les limites applicables aux appareils numériques de la classe B prescrites dans le
Règlement sur le brouillage radioélectrique édicté par le ministère des
Communications du Canada.
ANSI Warning
Equipment approved for UL 121201/CSA C22.2 NO. 213, Nonincendive Electrical
Equipment for use in Class 1, Division 2, Group A, B, C, and D.
Maximum ambient temperature: 40°C
WARNING: To prevent ignition of a hazardous atmosphere, batteries must only
be changed or charged in an area known to be non-hazardous.
EXPLOSION HARZARD WARNING: External connections/hubs through the
connectors as mentioned (USB connector, Ethernet connector, phone
connector, VGA port, HDMI port, DP port, serial port, power supply connector,
microphone jack, and headphones jack) are not to be used in a hazardous
location. When used with a docking station (such as the office dock or vehicle
dock), the docking/undocking of the equipment must be conducted outside the
hazardous area. Docking/undocking in a hazardous area is prohibited. Any
external card (such as the micro-SIM card and SD card) must not be removed
or replaced while the circuit is live or unless the area is free of ignitable
concentrations.
Power adapter shall not be used in hazardous locations.