Specifications

OEM/Integrators Installation Manual
Important Notice to OEM integrators
1. This module is limited to OEM installation ONLY.
2. This NFC module is limited to be integrated in specific host device, Getac B360 as
describe in FCC ID: QYLPN7462B, IC: 10301A-PN7462B filing.
3. For additional hosts other than the specific host originally granted with a limited
module, a Class II permissive change is required on the module grant to register the
additional host as a specific host also approved with the module.
4. For FCC Part 15.31 (h) and (k): The OEM integrators is responsible for additional
testing to verify compliance as a composite system. When testing the host device for
compliance with Part 15 Subpart B, the OEM integrators is required to show
compliance with Part 15 Subpart B while the transmitter module(s) are installed and
operating. The modules should be transmitting and the evaluation should confirm
that the module's intentional emissions are compliant (i.e. fundamental and out of
band emissions). The OEM integrators must verify that there are no additional
unintentional emissions other than what is permitted in Part 15 Subpart B or
emissions are complaint with the transmitter(s) rule(s).
5. OEM integrators are responsible for regression testing to accommodate changes to
designs, new antennas, and host and submit for C2PC filings. Colocation with other
transmitter modules will be addressed through filings for those co‐ located
transmitters when necessary or that colocation of other transmitters will be
according to applicable KDB guidelines including those for RF exposure.
End Product Labeling
When the module is installed in the host device, the FCC/IC ID label must be visible
through a window on the final device or it must be visible when an access panel,
door or cover is easily re-moved. If not, a second label must be placed on the outside
of the final device that contains the following text: “Contains FCC ID: QYLPN7462B”
“Contains IC: 10301A-PN7462B “
The FCC ID/IC ID can be used only when all FCC/IC compliance requirements are met.
Manual Information to the End User
The OEM integrator has to be aware not to provide information to the end user