User's Manual
Table Of Contents
- Chapter 1 Getting Started
- Chapter 2 Operating Your Computer
- Using the Keyboard
- Using the Touchpad
- Using the Touchscreen (Optional)
- Using Network and Wireless Connections
- Using the Optical Disc Drive (Select Models Only)
- Using the Fingerprint Scanner (Optional)
- Using the RFID Reader (Optional)
- Chapter 3 Managing Power
- Chapter 4 Expanding Your Computer
- Chapter 5 Using BIOS Setup
- Chapter 6 Using Getac Software
- Chapter 7 Care and Maintenance
- Chapter 8 Troubleshooting
- Preliminary Checklist
- Solving Common Problems
- Battery Problems
- Bluetooth Problems
- Display Problems
- DVD Drive Problems
- Fingerprint Scanner Problems
- The following message appears during the fingerprint enrollment process – “Your device is having trouble recognizing you. Make sure your sensor is clean.”
- The following message appears during the fingerprint login process – “Couldn’t recognize that fingerprint. Make sure you’ve set up your fingerprint in Windows Hello.”
- Hardware Device Problems
- Hard Disk Drive Problems
- Keyboard and Touchpad Problems
- LAN Problems
- Power Management Problems
- Software Problems
- Sound Problems
- Startup Problems
- WLAN Problems
- Other Problems
- Resetting the Computer
- System Recovery
- Using the Driver Disc (Optional)
- Appendix A Specifications
- Appendix B Regulatory Information
3
Connecting to AC Power
CAUTION: Use only the AC adapter included with your computer. Using other AC
adapters may damage the computer.
NOTE:
The battery pack is shipped to you in power saving mode that protects it from
charging/discharging. It will get out of the mode to be ready for use when you
install the battery pack and connect AC power to the computer for the very
first time.
When the AC adapter is connected, it also charges the battery pack. For
information on using battery power, see Chapter 3.
You must use AC power when starting up the computer for the very first time.
1. Plug the DC cord of the AC adapter to the power connector of the computer
(
).
2. Plug the female end of the AC power cord to the AC adapter and the male
end to an electrical outlet (
).
3. Power is being supplied from the electrical outlet to the AC adapter and onto
your computer. Now, you are ready to turn on the computer.