Owner's Manual

5-6
Using BIOS Setup and System Recovery
Ring Wake Up From S3 allows a modem device activity to wake up the
system from S3 (Sleep) state.
USB Wake Up From S3 allows a USB device activity to wake up the
system from S3 (Sleep) state.
Wake on PCH LAN allows a LAN activity to wake up the system from S3
(Sleep) state.
System Policy sets if the system always runs at full speed (
Performance ) or
lowers down when its temperature is too high (
Balance ).
AC Initiation sets if connecting AC power will automatically start or resume
your computer.
SATA Mode set to AHCI if your hard disk supports AHCI. AHCI allows you to
take advantage of Advanced Host Controller Interface features. The options
are
IDE and AHCI .
CAUTION: Incorrect SATA mode settings can result in hard disk drive boot
failure.
AMT Configuration configures Active Management Technology parameters.
Press Enter to access the submenu as shown below.
Advanced
AMT Configuration
Item Specific Help
Intel AMT:
Intel AMT Setup Prompt:
[Disable ]
[Disabled]
Enable/Disable
Intel (R) Active
Management Technology
BIOS Extension.
Note: iAMT H/W is
always enabled.
This option just
controls the BIOS
extension execution.
If enabled this
requires additional
firmware in the SPI
device
F1 Help ↑↓ Select Item +/- Change Values F9 Setup Defaults
Esc Exit ←→ Select Menu Enter Select  Sub-Menu F10 Save and Exit
Enabled