Quick Start Manual

6. Only for PCI Expansion Unit:

Replace the PCI card holder and secure with four screws (the screws

from step 2). Loosen the three screws (see circle below) so you can

slide the cramp along the guiding rails. Slide the cramp to the position

that holds the add-on card and then tighten the screws.

7. Replace the bottom cover and secure with 26 screws (the screws from

step 1).

8. To use the I/O connectors of your add-on card, open the access cover

by loosening two screws with your fingers or a flathead screwdriver.