User manual

DGBFNLIESNDKFINRUSGRESTLVLTPLPROSLOSKCZTRH
4 5
Gutkes GmbH
Rehkamp 13
30853 Langenhagen
Germany
Fax: [phone]
www.gev.de
[e-mail]
warranty cover damage resulting from
failure to observe these instructions.
Nor do we accept liability for any indirect
damage.
Similarly, we can accept no liability for
any material damage or bodily injury
caused by mishandling or failure to
observe the safety instructions. No
warranty claim may be made in these
cases.
In addition, for safety and compliance
reasons, you are not authorised to
dismantle or alter the device in any way.
Mounting position
Motion detection is maximised when
moving at an angle to the motion
detector. Therefore, the motion detector
should always be installed in a position
that ensures that objects/people do not
move directly towards the device.
Installation
Install the light as shown in Figs. B to
E. Connect the mains connection cable
as shown in the wiring diagram (Fig.D).
Settings
TIME use to set the ON period to
between approximatey 25 sec. and
5 min. (Fig. F).
LUX adjust the twilight switch to
between approximately 3 and 1,000 lux
(Fig. G).
By purchasing this item, you have
chosen a high-quality GEV product.
Please read these operating
instructions carefully to ensure
correct operation. Keep these
instructions in a safe place so that you
can refer back to them if necessary.
Operation
The LED fl oodlight with motion detector
functions using passive infrared
technology. If the motion detector’s PIR
sensor detects a moving heat source
in its fi eld of detection, it switches on
automatically. Static heat sources do
not activate the motion detector. The
adjustable twilight switch can be set
to ensure that the motion detector will
operate either during the day and night
or only when it is dark. When movement
is detected, the motion detector
switches on the LED and then switches
it o again between approx. 25 seconds
and approx. 5 minutes after the last
movement is detected, depending on
the setting.
Safety instructions
This device must be installed by
a technician, in accordance with
the applicable regulations. The
electrical power supply and the circuit
protection must be switched o during
the entire installation process. Please
check that the connection cable is
disconnected!
Under no circumstances does the
The motion detector can be adjusted
horizontally (Fig. H). You can also
restrict the angle of detection and the
range by attaching a lens mask, which
can be cut to size.
Adjust the fl oodlight to the required
position (Fig. I).
Recycling instructions
This device may not be disposed
of with unsorted household waste.
Owners of old devices are required
by law to dispose of this device
correctly. Contact your town council for
further information.
LED fl oodlight with motion detector
Technical data
Operating voltage 230 V ~, 50 Hz
Field of detection 140 °
Range approx. 8 m, depending on the installation height
Time setting approx. 25 seconds to 5 min, infi nitely variable
Twilight switch approx. 3 - 1,000 lux, infi nitely variable
LLL 14701 lamp power 1 x 4 W LED, maintenance-free
LLL 14718 lamp power 2 x 4 W LED, maintenance-free
LLL 14701 luminous fl ux 225 lumens
LLL 14718 luminous fl ux 450 lumens
Light colour 6,300 K
Colour rendering index min. Ra65
LED angle of radiation 30 °
Protection type IP44
Protection class II
Recommended installation height 1.8 m
LLL 14701 dimensions approx. W 75 x H 140 x D 145 mm
LLL 14718 dimensions approx. W 124 x H 140 x D 117 mm
Technical and design features may be subject to change without notice.