Power-Up Pulley Kit Installation Instructions Part # 2014 P.O. Box 1017 Riverwood NSW 2210 Ph: +612 9534 0099 Fax: +612 9534 3999 Website: www.gfb.com.au Email: sales@gfb.com.
GFB Subaru Power-Up Pulley Kit Fitting Instructions (part # 2014) The GFB Power-Up Pulley Kit is designed as a replacement for the original pulleys and increases engine power and response by reducing the inertial and driven loads, and also by under-driving the alternator and power steering pump. GFB recommends that this pulley kit is installed by a qualified motor mechanic, using the Subaru workshop manual guidelines.
Crank Pulley Removal/Installation • Removal of the factory crank pulley is done with a Subaru Crank Pulley Wrench (ST 499977300) or impact driver • Clean the crankshaft and thread, then slide the GFB crank pulley on. Clean the pulley bolt thread and tighten to a torque of 157 Nm A/C Belt Replacement • To replace the A/C stretch-fit belt, slide the supplied cable tie through one of the slots in the pulley on the right-hand side.
Pulley Installation IMPORTANT: BEFORE installing the alternator pulley, check the offset as shown below. MY06-on models typically have a longer pulley hub (these pulleys are usually stamped with the number 882 or 886 on the insde). In this case, use the supplied spacer to ensure the belt ribs on the GFB pulley are the same offset as the factory pulley as shown: • Install the GFB alternator spacer (if required) and pulley, tightening with the impact driver • Fit the GFB power steering pulley.
