Specifications

GFI FaxMaker 10 Appendix 2: Microsoft® Exchange 2007/2010/2013 Connector | 116
10 Appendix 2: Microsoft
®
Exchange 2007/2010/2013 Connector
When using GFI FaxMaker in a Microsoft
®
Exchange 2007/2010/2013 environment, configure SMTP
connectors torouteall emails addressed to faxmaker.com, smsmaker.com, fax: and sms: to GFI
FaxMaker.
NOTE
The default fax (faxmaker.com) and SMS(smsmaker.com)domains can be
customized by the GFI FaxMaker administrator. For more information, refer to Fax and
SMS domain names (page 26).
10.1 Creating the connectors automatically
GFI FaxMaker installed on Microsoft
®
Exchange Server
During installation, GFI FaxMaker automatically configures Microsoft
®
Exchange to allow processing of
faxes and SMS.
The setup creates a Foreign Connector and a Receive Connector named GFIFaxMaker.
No further configuration is required post-installation.
GFI FaxMaker installed on a separate machine
To configure connectors when installing GFI FaxMaker on a separate machine than Microsoft
®
Exchange 2007/2010/2013 Hub Transport role server:
1. Run the GFI FaxMaker setup on the Microsoft
®
Exchange Hub Transport server.
2. When choosing the components to install, disable GFI FaxMaker Fax Server and select Exchange
2000/2003/2007/2010/2013 SMTP connector.
3. In the next screen, specify the IP address or server name of the GFI FaxMaker server.
4. Proceed with installation.
The setup creates a Send Connector and a Receive Connector named GFIFaxMaker.
For more information refer to the Installation procedure section of the GFI FaxMaker Getting
Started Guide available from http://www.gfi.com/fax-server-software/manual/.
10.2 Creating the connectors manually
NOTE
When installing GFI FaxMaker on the Microsoft
®
Exchange Hub Transport server, the
connectors are automatically created during installation.
To create the connectors manually, from the Microsoft
®
Exchange Management Shell, run the
following commands:
1. Create a Receive Connector: