Specifications

GFI FaxMaker 3 General configuration settings | 13
Screenshot 7: Adding an ISDN channel
2. Specify the following details:
Setting Configuration
Available fax lines Select one of the available fax line numbers. This is used as a reference to that particular
line.
Device type Specify the type of fax device used.
Physical line/port Select the channel or port to configure.
Copy settings from
installed device
To copy the settings of a previously configured fax line, select this option and specify the
fax line to copy settings from.
Table 3: Add fax line options
Click OK.
3. From the Device tab in the line properties dialog, configure:
Device Type Settings
ISDN
ISDN BRI CAPI2.0
devices
ISDN PRI/IP
CAPI2.0 devices
ANALOG CAPI2.0
devices
Gateway devices
ISDN type - Select the ISDN device type.
MSN numbers - Enter the number to answer incoming calls for. Key in a full number entry
(for example, 82733099) or a prefix number (for example, 82733 to answer all numbers in the
range 82733000-8273099).
Answer All - Click to answer all incoming calls received on the ISDN channel.
Brooktrout Card type - Select the Brooktrout device type
Line capabilities - depending on the properties of your fax device, select the appropriate
type, None, DTMF or DID/ISDN.
Tone dialling - If supported, select for faster dialling. If disabled, pulse dialling is used.
Wait for dialtone - Starts dialling only when a dial tone is established.
Rings until answer - Configure the number of rings before answering incoming calls.
Table 4: Fax line device options