manual

Getting Started Guide Installation for Microsoft Exchange 2007 & 2010  55
Figure 4 - A typical Perimeter SMTP Relay Server setup
4.5.1 Pre-install actions
Step 1: Send and Receive connector setup
NOTE: These connectors are not required for Microsoft Exchange
Server 2007/2010 installed with Edge Server Role.
Ensure that the required Send connectors and Receive connectors to
and from Microsoft Exchange 2007/2010 are created for servers
installed with Hub Transport Role.
Where these are not yet created:
1. Add a „Send Connector‟ to Microsoft Exchange server to
forward all emails to the GFI MailEssentials machine
 From the Microsoft Exchange Server Management Console select
Organization Configuration ► Hub Transport ► Actions ►
New Send Connector
 In the New SMTP connector wizard, key in the name for the
connector in the introduction screen.
NOTE: You can use „GFI MailEssentials SMTP Connector‟.
 From the Select the intended use for this Send Connector drop
down list box select Internet.
 From the Address space screen click Add and key in *. Click Ok
and click Next.
 Choose Route mail through the following smart host, click Add
and specify the IP address of the server where GFI MailEssentials
is installed. Click Next.
 Set the authentication for the GFI MailEssentials machine (if