Ice Makers User Manual
01 02 Max 5 Bar Max 1 Bar 03 04
05 06 Açma-Kapama On-Off Buz kalınlığı Ice Size Dim Temizlik Cleaning 07 08 10 cm 20 cm 10 cm
Location: The ice machine must be located inside temperature controlled room. Running the ice machine outdoors or in an area that the temperature can go outside of the working limits may harm the machine, and your warranty may become void. Ice machines are designed and built with the highest respect for security. Location: In case the unit is located in an area with no side ventilation, ice maker does not work properly. Leaving enough room around the unit will allow the unit work properly.
Dear Customer, Your Ice-Maker was manufactured at the Eskişehir Facilities of TASİS Makine Mühendislik Sanayi ve Ticaret A.Ş. Please always have your Ice Maker installed by an Authorized Service. Your manufacturer’s warranty might become void in the case your Ice Maker has been installed by a third party service. NOTE: This User’s Manual has been issued for several models. Some features mentioned in this manual (indicated by *) may not be available on your product.
TABLE OF CONTENTS Chapter 01..... Safety warnings Chapter 02..... General Outlook and Technical Specifications Chapter 03..... Installation of Your Ice Maker Chapter 04..... Operating Instructions Chapter 05..... Cleaning and Maintenance Chapter 06..... Troubleshooting Chapter 07.....
Chapter 01. Safety warnings 1. Always plug in your product to a grounded power outlet. 2. Your ice maker is designed to operate at voltage shown on Technical Table. Running the product at a different voltage may cause the product to become dysfunctional or even may cause fire. 3. Do not place your ice maker next to any heat source. 4. Set up your ice maker at a humidity-free location and with un-obstructed air circulation around the unit. 5.
Chapter 02. General Outlook and Technical Specifications Ice Storage Bin Lid Multifunction Button Group Stainless Steel Cabinet Ventilation Filter Adjustable legs* Adjustable Legs* Ürünlerde farklı görsel elde edilmesi, görüntüleme teknolojileri veya diğer teknik nedenlerden dolayı renk ve diğer çeşitlilikler açısından küçük farklılıklar görülmesi mümkündür. Üretici bu farklılıklar ve sapmalardan sorumlu değildir.
Technical Table Product Code Refrigerant Gas Production Capacity (kg) Storage Capacity (kg) Ice Capacity Per Cycle (Unit) Ice Type Cooling System Climate Class Voltage Maximum Power Daily Electric Consumption Fuse ** Product Weight (kg) Product Dimension (w*d*h) Packing Dimension (w*d*h) Loading Quantities (20DC) Loading Quantities (40HC) Loading Quantities (Tr.
Chapter 03. Installation of Ice Maker Selection of Location for Your Product Your product should not be in direct contact with or in close proximity to any heat source. You should leave at least 10 cm of distance if you place your ice maker next to other electrical equipment (such as ovens, computers etc,) that are considered as heat sources. If the product is to be placed next to a wall, the distance between the back surface of the product and the wall should not be less than 20 cm (See Figure-7).
Installation ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ Remove and disassemble all packaging materials of the product before installation. The ice slide grate, waterproofing plastics and the ice scoop are provided inside the product. If any part or accessory is missing, please contact our customer services. Clean the inner cabinet with warm water and a soft cloth before using the ice maker. Clean the ice trays with warm soapy water. Dry with a soft, cotton cloth.
Chapter 04. Use of the Ice Maker Operating the Ice Maker After installing your Ice Maker following the instructions above and making all necessary connections; 1. 2. 3. 4. 5. 6. 7. Make sure that the power outlet you are using for your ice-maker is live and has power. Turn on the water. Set the On-Off button at the front of your product to the On position. (When you set it to the On position, the power light on the button will turn on.
Chapter 05. Cleaning and Maintenance of Your Ice Maker Safety rules must be observed before cleaning your Ice Maker: 1. 2. 3. 4. 5. Unless otherwise specified, turn off and unplug the unit before starting to clean the Ice Maker. The outer cabinet of the product should only be cleaned by wiping with a damp cloth. Do not spray the unit with water or any other cleaning solvent. This causes undesired electrical failures and jeopardizes the safety of the user.
Do not turn off the product while cleaning is in progress. After the cleaning process, discharge the water inside the inner basin. (See figure 3) Right after this cleaning, the Ice Set must be cleaned. Cleaning of the Ice Set To remove the top cover, remove the screws in “Figure-6”. Remove the plastic cover on the cooling pipes. Clean the cooling pipes and visible surfaces in the tank with cleaning solution / soapy cloth. Then rinse and then dry.
Chapter 06. Actions to be Taken Before Calling Authorized Service Malfunction Probable Reason Solution Ice Maker does not work Power button is Off. Set the power button to the “On” position. Get the power connection checked by a qualified electrician. The power connection is faulty. The Ice Maker is in protection mode. The compressor stops shortly after it starts working No power in the outlet.
Malfunction Probable Reason Solution Ices are much smaller than they should be. Water is insufficient Ices are much bigger than they should be. The quantity of the ice is insufficient Time setting is incorrect Sensor is faulty Place the water level plastic group to its slot tightly. Check the water main connection for the water leakage. Contact the nearest Authorized Service. Set the time on the electronic card to a lower value. Contact the nearest Authorized Service.
Chapter 07. Scope of Warranty Dear Customer, This warranty provided by our company does not cover the repair of defects caused by unusual use of the ice maker, and the following items are excluded from the warranty.
Measuring the Mains Water Supply Hardness and Use of Water Filter NOTE: ............................................................................................................................. .............. ........................................................................................................................................... ............................................................................................................................. .............. .................
........................................................................................................................................... ............................................................................................................................. .............. ............................................................................................................................. .............. ..........................................................................................
110122010