User Manual

ManualsBrandsggm gastro ManualsGriddle SmoothGGM Gastro SGD120 Electric Griddle Smooth

COMMERCIAL REFRIGERATOR AND FREEZER

USER’S MANUAL

Back Bar Coolers

Models: SGD120, SGD240, SGD150, SGD250, SGD315, SGC-2, SGC-3

Upright Bottle Coolers

Models: SGD300, SGD500

Beer Keg Coolers

Models: SKC-2, SKC-4, SKC-6, SKC-8

PLEASE READ THE MANUAL THOROUGHLY PRIOR TO

EQUIPMENT SET-UP, OPERATION AND MAINTENANCE.

Summary of content (6 pages)

PAGE 1
COMMERCIAL REFRIGERATOR AND FREEZER USER’S MANUAL Back Bar Coolers Models: SGD120, SGD240, SGD150, SGD250, SGD315, SGC-2, SGC-3 Upright Bottle Coolers Models: SGD300, SGD500 Beer Keg Coolers Models: SKC-2, SKC-4, SKC-6, SKC-8 PLEASE READ THE MANUAL THOROUGHLY PRIOR TO EQUIPMENT SET-UP, OPERATION AND MAINTENANCE.
PAGE 2
INSTALLATION/ OPERATION IMPORTANT!!! PLEASE READ BEFORE INSTALLATION ■ If the unit has recently been transported please let unit stand still for a minimum of 24 hours before plugging it in. ■ Make sure that the unit drops down to desired temperature before loading the unit with product. ■ Make sure that there is proper ventilation around the unit in the area where it will operate. ■ Make sure all accessories are installed (i.e. shelves, shelf clips, casters) before plugging the unit in.
PAGE 3
All electrical work must be carried out by suitably qualified persons ELECTRICAL Please ensure that the required voltage of the compressor is being supplied at all times. Low or high voltage can detrimentally affect the refrigeration unit. All units should be plugged into a grounded and properly-sized electrical outlet with appropriate overcurrent protection. Please refer to the electrical requirements on the nameplate of the unit. Please make sure that your unit has its own dedicated outlet.
PAGE 4
SAFETY / WARNING Please pay close attention to the safety notices in this section. Disregarding these notices may lead to serious injury and/or damage to the unit. ATTENTION ■ To minimize shock and fire hazards, be sure not to overload outlet. Please designate one outlet for your unit. ■ Do not use extension cords. ■ Do not put your hands under the unit when the unit is required to be moved. ■ When the unit is not in use for a long period of time, please unplug the unit from the outlet.
PAGE 5
REGULAR MAINTENANCE CLEANING THE CONDENSER COIL ■ For efficient operation, it is important that the condenser surface be kept free of dust, dirt, and lint. ■ We recommend cleaning the condenser coil and fins at least once per month. ■ Clean with a commercial condenser coil cleaner, available from any kitchen equipment retailer. Brush the condenser fins from top to bottom, not side to side. ■ After cleaning, straighten any bent condenser fins with a fin comb.
PAGE 6
TROUBLE SHOOTING Before requesting any service on your unit, please check the following points. Please note that this guide serves only as a reference for solutions to common problems. SYMPTOM POSSIBLE CAUSE CORRECTIVE ACTION Compressor not running. Fuse blown or circuit breaker tripped. Power cord unplugged. Thermostat set too high. Replace fuse or reset circuit breaker. Plug in power cord. Set thermostat to lower temperature. Wait for defrost cycle to finish.