MSDS

ManualsBrandsGhostshield ManualsPaint1-gal. Concrete and Masonry Cleaner

MATERIAL SAFETY DATA SHEET

SECTION 1: PRODUCT AND COMPANY IDENTIFICATION

PRODUCT NAME: GHOSTSHIELD X-TEK 1000

MANUFACTURER: Kretetek Industries

STREET ADDRESS: 1000 N West Street

CITY, STATE, ZIP: Wilmington, DE 19801

INFORMATION PHONE: 855-573-8383

EMERGENCY PHONE: Chemtrec 800-424-9300

DATE REVISED: 1/1/14

SECTION 2: COMPOSITION/INFORMATION ON INGREDIENTS

INGREDIENT CAS NO. OSHA PEL ACGIH TLV OSHA STEL WEIGHT %

OCTYLPHENOXYPOLYETHYOXYETHANOL 9036-19-5 NONE NONE NONE

*N-METHYL-2-PYRROLIDONE 872-50-4 100PPM 100PPM 100PPM 4

WATER 7732-18-5 NONE NONE NONE

MONOCYCLIC TERPENE HYDROCARBONS UNKNOWN NONE NONE NONE

TRIETHANOLAMINE (ALKANOLAMINE) 102716 NONE NONE NONE

SECTION 2 NOTES: *Indicates toxic chemical(s) subject to reporting requirements of section 313 of Title III and of 40 CFR 372.

SECTION 3: PHYSICAL AND CHEMICAL PROPERTIES

APPEARANCE AND ODOR: BLUE LIQUID WITH SOLVENT ODOR

BOILING POINT OR RANGE: 396F

VAPOR DENSITY (AIR = 1): HEAVIER THAN AIR

SPECIFIC GRAVITY (H2O = 1): 1.0

EVAPORATION RATE: SLOWER THAN ETHER

SOLUBILITY IN WATER: SOLUBLE

SECTION 3 NOTES:

SECTION 4: FIRE-FIGHTING MEASURES

FLAMMABLE LIMITS IN AIR, UPPER: N/A

(% by volume) LOWER: N/A

FLASH POINT: >200 F

METHOD USED:

SETA FLASH

EXTINGUISHING MEDIA:

OTHER

SPECIAL FIRE FIGHTING PROCEDURES:

DO NOT ENTER CONFINED AREA WITHOUT FULL BUNKER GEAR INCLUDING A POSITIVE PRESSURE NIOSH APPROVED SELF-CONTAINED

BREATHING APPARATUS.

UNUSUAL FIRE AND EXPLOSION HAZARDS:

IF FIRE OCCURS, SOLVENTS MAY PRODUCE EXCESSIVE PRESSURE. SEALED DRUMS MAY RUPTURE AND IGNITE. VAPORS ARE HEAVIER

THAT AIR AND MAY TRAVEL ALONG THE GROUND AND IGNITE BY ANY SOURCE OF IGNITION. NEVER USE A CUTTING OR WELDING

TORCH NEAR CONTAINERS (EVEN EMPTY). ALL 5 GALLON AND LARGER CONTAINERS SHOULD BE GROUNDED BEFORE

TRANSFERRING MATERIAL.

Summary of content (4 pages)

PAGE 1
MATERIAL SAFETY DATA SHEET SECTION 1: PRODUCT AND COMPANY IDENTIFICATION PRODUCT NAME: GHOSTSHIELD X-TEK 1000 MANUFACTURER: Kretetek Industries STREET ADDRESS: 1000 N West Street CITY, STATE, ZIP: Wilmington, DE 19801 INFORMATION PHONE: 855-573-8383 EMERGENCY PHONE: Chemtrec 800-424-9300 DATE REVISED: 1/1/14 SECTION 2: COMPOSITION/INFORMATION ON INGREDIENTS INGREDIENT CAS NO.
PAGE 2
MATERIAL SAFETY DATA SHEET SECTION 4 NOTES: SECTION 5: STABILITY AND REACTIVITY STABILITY: STABLE CONDITIONS TO AVOID (STABILITY): AVOID EXCESSIVE HEAT OR OPEN FLAMES AS WELL AS ALL SOURCES OF IGNITION SUCH AS SPARKS, HEATERS, STATIC DISCHARGES ETC.. INCOMPATIBILITY (MATERIAL TO AVOID): AVOID CONTACT WITH STRONG OXIDIZING AGENTS, AND STRONG ACIDS AND BASES. HAZARDOUS DECOMPOSITION OR BY-PRODUCTS: MAY FORM TOXIC CHEMICALS, CARBON DIOXIDE, CARBON MONOXIDE AND VARIOUS HYDROCARBONS ETC..
PAGE 3
MATERIAL SAFETY DATA SHEET NOTES TO PHYSICIANS OR FIRST AID PROVIDERS: SECTION 7 NOTES: SECTION 8: RELEASE MEASURES STEPS TO BE TAKEN IN CASE MATERIAL IS RELEASED OR SPILLED: WEAR RESPIRATOR AND PROTECTIVE CLOTHING. REMOVE ALL SOURCES OF IGNITIONS. REMOVE EXCESS WITH VACUUM TRUCK AND TAKE UP THE REMAINDER WITH AN ABSORBENT SUCH AS CLAY AND PLACE IN DISPOSAL CONTAINERS.
PAGE 4
MATERIAL SAFETY DATA SHEET THE INFORMATION CONTAINED HEREIN IS BASED ON THE DATA AVAILABLE AND IS BELIEVED TO BE ACCURATE, HOWEVER, THE MANUFACTURER MAKES NO WARRANTY EXPRESSED OR IMPLIED REGARDING THE ACCURACY OF THIS DATA OR THE RESULTS OBTAINED FROM THE USE THEREOF. ACCORDINGLY, WE ASSUME NO RESPONSIBILITY FOR INJURY FROM THE USE OF THIS PRODUCT.