Use and Care Manual

!
Technical Data Sheet
1000
PRODUCT DATA
TECHNOLOGY // ADVANTAGES
KreteTek Industries Inc. 66 River Road Hudson NH 03051 // 855-573-8383 // www.ghostshield.com
•
Etches concrete - cleans and give porosity before sealing
•
Brightens concrete and masonry
•
Helps remove excess mortar from brick
•
Concentrated - "one gallon makes up to 6 gallons
•
Removes white salt deposits"(efflorescence) from brick,
concrete and masonry
•
Removes dirt and stains - and cleans algae and scum!
TYPICAL PROPERTIES!
Appearance - Yellowish, clear liquid!
Packaging - 1 gallon concentrate (3.78 L), 55 gallon (208 L) drums
Precautions
CAUTION: Wear protective clothing, rubber gloves and plastic safety
goggles while using. Contact with eyes can cause irreversible
damage and permanent blindness. Contact with skin (even for a few
moments) can cause severe burns. Ingestion may be fatal.
DANGER: POISON! Keep out of reach of children and pets. May be
fatal if swallowed. Causes severe burns and vapor is harmful.
Application
1. Caution! Always add Hydro-Etch 1000 to water, not water to
Hydro-Etch 1000. If you pour water into Hydro-Etch 1000 it can
cause an explosive reaction that can spray you with the mixture and
burn your skin! Mix solution slowly in an open-top plastic container.
Do not splash. Stir gently with plastic or bare wood. Ratio varies by
desired use: use a higher ratio for cleaning or a lower ratio for
etching. Sample and test on a small area until desired effect is
achieved. Suggested dilution ratio for etching concrete is one (1)
part Hydro-Etch 1000 to one (1) part water.
2. Before cleaning or etching, make sure the concrete is free of all oil,
contaminants, grease, and dirt. Contrary to what many people think,
acid will not clean grease and oil spots. In fact, if these areas have not
been cleaned and degreased properly, the acid solution will just sit
on top and not react with the concrete.
2
Sections
03
03 91 00
Concrete Cleaning