Use and Care Manual

ManualsBrandsGhostshield ManualsBuilding materials1-gal. Water Based Concrete and Masonry Water Repellent with Matte/Satin Finish

Technical Data Sheet

ULTRAVIOLET (UV) EXPOSURE AND WEATHERING

5500

PRODUCT DATA

Sections

HIGH PERFORMANCE, CLEAR, WATER BASED

ACRYLIC SEALER THAT ENHANCES PROTECTS AND

PROVIDES A CLEAR “WET LOOK” THAT HIGHLIGHTS

NATURAL PIGMENTS IN THE CONCRETE.

CRYLI-TEK® 5500

09 97 00

Special Coatings

A new high performance

nanotechnology driven clear low

sheen water based acrylic.

Cryli-Tek® is an acrylic,

waterborne, high solids sealer

for new or existing decorative

concrete. It brings out the “wet

look” and highlights the natural

pigments in the surface, all

while protecting it against

abrasion and damage.

This unique formula leaves the

surface with a clear, low gloss,

non-yellowing ﬁnish. This

product has an extremely fast

set time and unsurpassed stain

resistance. The treated surfaces

will resist chipping, ﬂaking,

delamination and breakdown

with UV light exposure.

Solids!

25%

Appearance/color!

Clear

Coverage!

100-300 ft²/gallon

KreteTek Industries Inc. 66 River Road Hudson, NH 03051 // 855-573-8383 // www.ghostshield.com

Percentage Improvement vs. Control

CRYLI-TEK®

5500

Low solids

coating

Traditional

coating

Leading brand

coating

27%

33%

44%

52%

Meets the requirements of:

ASTM D 3359, ASTM D 3363,

ASTM D 4541, ASTM G 155,

ASTM D 2047, ASTM C 309,

AASHTO Des M-148,

ACI Standard 302-77

Description

Summary of content (4 pages)

PAGE 1
5500 PRODUCT DATA Technical Data Sheet Sections 97 00 09 09 Special Coatings CRYLI-TEK® 5500 HIGH PERFORMANCE, CLEAR, WATER BASED ACRYLIC SEALER THAT ENHANCES PROTECTS AND PROVIDES A CLEAR “WET LOOK” THAT HIGHLIGHTS NATURAL PIGMENTS IN THE CONCRETE. Description ULTRAVIOLET (UV) EXPOSURE AND WEATHERING A new high performance nanotechnology driven clear low sheen water based acrylic. Cryli-Tek® is an acrylic, waterborne, high solids sealer for new or existing decorative concrete.
PAGE 2
5500 PRODUCT DATA Technical Data Sheet Sections 97 00 09 09 Special Coatings TECHNOLOGY // ADVANTAGES • Composition - 25% solids nanotechnology driven highperformance water based acrylic.
PAGE 3
Sections 97 00 09 09 Special Coatings PRODUCT DATA APPLICATION Surface Prep 1. New “green” concrete must be properly cured. Concrete should obtain 80% of design strength, typically achieved within 14-28 days. 2. The concrete substrate must be structurally sound and clean of oil, grease, dirt, wax, curing compounds, ef orescence, paints, previous sealers, adhesives and other contaminants that might interfere with the penetration of the sealer.
PAGE 4
5500 PRODUCT DATA Technical Data Sheet Sections 97 00 09 09 Special Coatings APPLICATION Warranty Best Performance • • • • • • • Proper application is the responsibility of the user. Make sure the most current versions of technical data sheets and safety data sheets are being used. Do not use in immersion service or constant chemical exposure areas. Extremely porous substrates such as pavers may require additional coats to achieve a slight enhancement. Apply in temperatures above 50°F.