Use and Care Manual

TECHNICAL DATA SHEET
KreteTek Industries Inc. | 1000 N West St Wilmington, DE 19801 | 855-573-8383 | www.ghostshield.com
Step 1:
The concrete substrate must be structurally sound, thoroughly dry and clean. Wait at least 24-48
hours after rain and/or pressure washing before sealing; concrete should be visibly dry.
Step 2:
Remove all paints, previous sealers and/or adhesives before application.
Step 3:
The substrate must be clean of oil, grease, dirt, wax, curing compounds, efflorescence and other
contaminants that might interfere with the penetration of the sealer.
Step 4:
If acid is used to clean the concrete, neutralize the surface completely and rinse it with water prior to
application. Then wait for the concrete to dry out for at least 24-48 hours.
Step 5:
The surface-zone moisture content of the concrete should not exceed 4%wt.
Step 6:
Cover all surrounding areas not intended to be coated.
Step 7:
New concrete must be cured for at least 28 days before sealing.
APPLICATION
Step 1:
Countertop Sealer 770 is a concentrated product that needs to be mixed with water prior to
application. We recommend using a bucket to mix the sealer. Pour the 16 oz. container of Countertop Sealer
770 into a bucket.
Step 2:
Next fill up the bucket with 48 oz. of water (distilled water is preferred). (Countertop Sealer 770 can
be mixed in smaller quantities as long as the one (1) part Countertop Sealer 770 to three (3) parts water ratio
is followed. For example, one (1) cup Countertop Sealer 770 can be mixed with three (3) cups of water).
Step 3:
Stir the Countertop Sealer 770 and water mixture well before using.
Step 4:
Dip either a small nap roller or brush into the bucket of mixed material.
Step 5:
Roll or brush one coat onto the countertop.
Step 6:
Immediately apply a second coat to the countertop, while the first coat is still wet. Apply until the
surface is saturated but not to the point of puddling. (Since the Countertop 770 is a hydrophobic product if
you try to apply a second coat after the first coat has dried, the first coat may try to repel the second coat).
Step 7:
Roll or brush out any puddles until the sealer penetrates the substrate.
Step 8:
When the entire application has been treated with two (2) coats, let the concrete dry for at least six
(6) hours before light use and at least 24 hours before placing objects back on the countertop and normal
everyday use.
Step 9:
Clean up: Application tools can be cleaned using soap and water.
Step 10:
Unused or old material may be disposed of in a waste disposal site in accordance with local, state
and federal laws.