READ AND SAVE INSTRUCTIONS
To reduce the risk of electrical shock,ensure the electricity has been turned off at the circuit breaker or fuse box before beginning. All wiring must be in accordance with the National Electrical Code NASI / NFPA 70-1999 and local electrical codes. Electrical installation should be performed by a qualified licensed electrician. The outlet box and support structure must be securely mounted and capable of reliably supporting 35lbs(15.9kg).
EE EE Mounting screws and cushion(Outlet box) L M H I LED Light Kit Assembly Wall control 3 Acrylic Shade 4
Cushion Mounting screws 5
Install downrod assembly 1. Thread the suspender through the suspended clock and coupling cover. 2. Then insert the tail of the suspender from the lifting head of the motor. 3. Remove the lateral pin out from the suspended head position, secure with R type pin(Clevis pin). 4. Tighten the lifting head screws. Tighten the 2 Set Screws on the Coupling to serve as a clamping force on the Downrod to prevent fan shaking during operation. 5.
Install the canopy 1. Carefully push the canopy to the bottom of the mounting bracket, make two sliding holes aligned to the two prominent screws on the mounting bracket, and then turn clockwise until tight. 2. Push the canopy ring to the bottom of the canopy, slide the inner holes aligned to the two prominent screws on the mounting bracket again, and turn the canopy ring clockwise until tight.
1. Connect the light kit with the motor, put the light kit into the light kit assembler. 2. Use 3 screws to lock the light source.
All fans are shipped from the factory with the reversing switch positioned "left " to circulate air downward. If airflow is desired in opposite direction, turn your fan OFF and wait for the blades to stop turning, then slide the reversing switch to the "right" position, and turn fan on again ( As shown here ). The fan blades will turn in the opposite direction and reverse the airflow.
How to Wire Your Ceiling Fan L M H I 10
Please check and follow the instructions: Chapitre Fan balance on page 11.
