Owner’s Manual & Installation Guide Contemporary Faucets Note: Read all instructions before proceeding with installation. All specifications are subject to change without notice.
Table of Contents: Installing a Floormount Faucet......................................................................................................................1 Installing a Wallmount Faucet........................................................................................................................4 NOTE: Due to the complexities of this installation a professional plumber is required.
CONTEMPORARY FLOOR MOUNT TUB FAUCET Notes: 1. Faucet is not for use on concrete floors. 2. Please ensure all local plumbing codes are observed during installation 3. Water supply lines must be roughed in on 8” centers. C-HLVR 1 17 1 Screw 16 Spokes 10 7 (Allen Wrench) Union Nut Spokes 3 C-FRSR 9 16 C-HCRS C-FB1 Step 1 Install #1 spout into Step 2 Screw #16 handle hub C-FRSR faucet body by pushing straight onto hot/cold cartridges #9 & #17. down.
CONTEMPORARY FLOOR MOUNT TUB FAUCET (cont.) Step 8- Slide #25 decorative escutcheon down to cover floor flange. Step 9- Tighten optional support bracket to risers and drain 8" FIGURE 5 Supply line spacing 16 30 Step 10- Attach small end of #18 handshower hose with #30 washer to outlet below diverter faucet handle. Step 11- Attach large end of #18 hand shower hose to #16 handshower with #30 washer and place in holder.
SUPPORT BRACKET INSTALLATION (for floormount faucets) STEP 7 STEP 1 STEP 7 FIGURE 1 Bracket Assembly FIGURE 2 & 3 Slide Bracket FIGURE 4 Bend Strap FIGURE 5 Secure Strap 1. Assemble bracket as shown. 2. Slide support bracket onto risers before decorative escutcheons. 3. Bend metal strap around drain to create a clamp. Secure with screw provided. Recommended height is just below drain overflow. 4. Proceed with step 6 of faucet installation.
CONTEMPORARY WALL MOUNT TUB FAUCET Notes: 1. Please ensure all local plumbing and building codes are observed when installing these faucets. 2. Mounting location depends on tub design and location. Be sure to identify tub height when determining faucet location. 3. There must be a minimum of 2" gap between top of tub rim and bottom of the faucet spout to comply with plumbing codes. 4. Water supply lines must be roughed in on 8” centers.
CONTEMPORARY WALL MOUNT TUB FAUCET (cont.) Finished Wall Step 3: Rough-in #29 C-WLBO flush to finished wall. Hot/Cold supplies should be roughed in on 8” centers and 1/2” pipe should extend 3/8” to 1/2” beyond the finished wall. Step 4: Screw #28 decorative flange included with C-WLBO onto rough portion of #29. C-FB1 3/8"-1/2" C-WLBO (29) Step 5: Attach faucet to wall by screwing the union nuts onto the C-WLBO wall elbows with #10 washers.
Contact information Giagni 550 South Columbus Avenue Mount Vernon, New York 10550 Phone: 888-560-5222 Fax: 888-560-8727 G i a g ni
