User Guide

Maintenance

General Maintenance

 Inspect all suspension bolts and tighten if necessary to required torque

settings.

 Do not use high-pressure water sources to wash or rinse bicycle. Doing so

can displace any lubricants that are present, as well as possibly forcing

water and/or contaminants into the bearing that can harm the pivot and

bearing, reduce performance, and cause premature wear. Use only low

pressure water, or bucket water with a soft nylon bristle brush and mild dish

soap to clean the frame and components.

 Always use Loctite

Primer (#7649) and Loctite

blue Removable

Threadlock (#242) or similar material on thread of fixing bolts of calipers

and rotors during re-assembly.

Replacement of rear shock

Steps 1:

Loosen the shock mounting bolt

and remove the shock.

Repeat Step 1 in reverse to reassemble the rear shock.

Shock mounting bolt

Recommended torque for the shock mounting bolt is 90-110 kgf-cm.