Product Info

If your GH4010 is not performing to your expectations, please try
these simple steps:
Problem
Suggestion
Charge light won't come
on when handset is placed
in base unit.
No dial tone.
Can't make outgoing calls.
Handset doesn't ring.
Make sure the AC Adapter is plugged
into the base unit and wall outlet.
Make sure the wall outlet is functioning.
Make sure the handset is properly
seated in the base unit.
Make sure the rechargeable battery
pack is properly placed in the handset.
Make sure that the charging contacts on
the handset and on the base unit are
clean.
TROUBLESHOOTING
Charge the handset for 10 hours before
initial use.
Place the handset back into cradle for 5
seconds.
Make sure the handset is fully charged.
The CHARGE LED should light when the
handset is in the cradle.
Make sure the Tone/Pulse switch is set
to the correct setting. If set to the Tone
mode, switch to Pulse. You may have
pulse dia ling service.
side of the handset is set to the "On"
position.
not fully charged. Charge the battery pack
for 4-5 hours.
upright position.
The handset may be too far away from the
base unit.
the base unit and wall outlet
installed on the same line. Contact your
local telephone company to determine the
maximum number of extensions for your
calling areas.
Rechargeable battery pack may be weak or
Make sure the Ringer On/Off switch on the
Make sure the base antenna is in the
Make sure the AC adaptor is plugged into
Make sure the wall out lot is functioning.
There may be too many telephones
27