User's Manual
Table Of Contents
- SAFETY AND GENERAL INFORMATION
- Important Information for Safe and Efficient Operation
- Safety and General
- Two-way Radio Operation
- Approved Accessories
- OPERATIONAL CAUTIONS
- FCC LICENSING INFORMATION
- FCC STATEMENTS:
- CONTROL BUTTONS AND DISPLAY ICONS–
- MODEL R1010 SERIES
- GETTING STARTED
- INITIAL SETUP
- TALKING AND LISTENING
- SPECIAL FEATURES
- ACCESSORIES
- WARRANTY
2. Press
or to select the code.
3. Press PTT to save the code setting or MENU to continue set up.
You can set a different code for each channel using this procedure. Press and hold
or to
scroll through the Interference Code rapidly so you can quickly reach the code you want.
Note: You must set the Interference Eliminator Code to 0 on a radio that uses Interference
Eliminator Codes to communicate with radios that do not have Interference Eliminator Codes.
Select 0 for “no tone, no code”
Scanning Channels
Use scanning to monitor channels and codes for transmissions or to find someone in your group
who has accidentally changed channels.
To start scanning, briefly press and release
. The scan indicator displays “Z” and the radio
begins to scroll through the channel and Interference Eliminator Code combinations. When the
radio detects channel activity, it stops scanning and you can hear the transmission. To respond to
the transmission, press
or PTT Boost within five seconds.
To stop scanning, briefly press and release
.
(29-09) R1010 IB 1_0B 050928.doc