User's Manual
14
Operating the Walkieí7alkies
9
Resuming channel scanning
or Resume channel scanning
Excluding a channel
If a channel found during the channel scanning process should
not be considered for subsequent use, it can be excluded.
All the channels are taken into consideration again when a new
channel scan is started. During the time that the walkieítalkie is
temporarily stopped on the unwanted channel, press and hold
the
/ for 3 seconds to exclude that channel.
, 3 sec. or 7he channel is excluded and
channel scanning automatically
resumed
7UDQVPLt ringing tone
7KH ringing tones indicate to other subscribers that you want to
talk to them. A condition for this is that the other subscribers are
using the same channel and &7&66/&'&66 code.
6end ringing tones
6HOHFWLQJ'HDFWLYDWLQg the ringing tone
7here are 10 rLQJLQJWRQHVDYDLODEOHIRr selection. 7oGHDFWLYDte
3 x ActiYate programming mode
or , 6elect the ringing tone and
confirm it
Monitor
7he Monitor function enables the search for weak signals on the
channel currently set. If you rHFHLYHDQH[WHrnal signal, switch to
a free channel. Always communicate with other subscribers on a
free channel to prHYHQWLQWHrference.
, Monitor the channel
, End the monitoring function