User Manual

Table Of Contents

Do not remove, install, or charge batteries in such areas. Sparks in a potentially explosive

atmosphere can cause an explosion or fine resulting in bodily injury or even death.

Note: The areas with potentially explosive atmospheres referred to above include fueling

areas such as below decks on boats, fuel or chemical transfer or storage facilities,

areas where the air contains chemicals or particles, such as grain, dust, or metal

powders, and any other area where you would normally be advised to turn off your

vehicle engine. Areas with potentially explosive atmospheres are often but not always

posted.

Blasting Caps and Areas

To avoid possible interference with blasting operations, turn off your radio when you are near

electrical blasting caps, in a blasting area, or in areas posted: “Turn off two-way radio.” Obey

all signs and instructions.

Operational Cautions

Antennas

Do not use any portable radio that has a damaged antenna. If a damaged antenna comes

into contact with your skin, a minor burn can result.

Batteries

All batteries can cause property damage and/or bodily injury such as burns if a conductive

material such as jewelry, keys, or beaded chains touch exposed terminals. The conductive

material may complete an electrical circuit (short circuit) and become quite hot. Exercise care

in handling any charged battery, particularly when placing it inside a pocket, purse, or other

container with metal objects.

Battery Charger Safety Instructions

Save these Instructions

1. Do not expose the charger to rain or snow.

2. Do not operate or disassemble the charger if it has received a sharp below, or has been

dropped or damaged in any way.

3. Never alter the AC cord or plug provided with the unit. If the plug will not fit the outlet,

have the proper outlet installed by a qualified electrician. An improper condition can

result in a risk of electric shock.

4. To reduce the risk of damage to the cord or plug, pull the plug rather than the cord when

disconnecting the charger from the AC receptacle.

5. To reduce the risk of electric shock, unplug the charger from the outlet before attempting

any maintenance or cleaning.

6. Make sure the cord is located so it will not be stepped on, tripped over, or subjected to

damage or stress.

The content of this document is Giant Electronics Ltd.'s intellectual property and is the property of Giant. It is to be

treated as strictly confidential and is not to be disclosed, reproduced, or used except as authorized in writing by Giant

Electronics Ltd. In connection with the manufacture, maintenance and use of the Giant equipment to which it pertains.

Page 4 of 12