Users Manual

Network
lights
Network
Host:
The green led lamp is often turned off on the host
standby.After the host increases the slave device, the led is
often bright for 4 minutes, allowing the slave device to join
the host for data acquisition.
From the machine:
After connecting the host, the green light always shines, the
line or the distribution network often extin
g
uished.
Description of
the host
operating
interface
Host: (attached Figure A host interface description)
There are 4 keys on the host: set, add, sub, print
There are 2 indicators on the host: Power, Network
Set ：
Short press for switching and selection of the OLED
interface
Press 3S to open the allowable net for 4 minutes and
illuminate the Network indicator on the host.Allow slave
host to remind (not the same slave address code of the
same network, the same address code can not join the
host)
add
：
Short press for project selection and move to the right
sub
：
Short press for project subtraction selection, move left
Print:
Short press to print reports or print test pages
Power:
Host power supply indicator lamp.There are 3 power supply
modes.Among them, the power supply and printer can
mainly meet the communication through the telephone line
6P interface.Other 2 alternatives (micro USB, External 6P
connector)
Network
：
Networking indicator, only 4 minutes.(After networking, the
host or from the zigbee connection)
From the
machine
button
Description
From: (Figure B slave interface)
There are two main keys on board: set, print
There are 2 indicators on board: Power, NET
set:
Short press start to add net
Press the factory for 4 seconds to resume
Print:
Short press are used for interface switching
A long press of 4S used for test printing
Power:
Power supply indicator lamp from the machine.Connect to
the game console through the external 6P connector,
connect the required red line to the 12V DC black cable to
the GND (allow the input of 5V
—
24V DC power supply from
the machine)