Users Manual

Host long press set button 3S after let go, see the Network green light on
the host for 4 minutes, short press set, from the machine to see the
green light, the network is successful.
1.3.2 print test
The dialing code on the printer goes to 9600
, and the host also
goes to 9600
。
Power the host.If the host can press the Print button,
and the test page can print that the host power supply and communication meet
the conditions.After getting from the unit network, the NET indicator light is on,
and long press print 4 second, to test and print it out, indicating that there is no
problem with the power supply and communication from the machine and the
host.
1.3.3 restore factory setting
Host:
After logging in to the system, select restore factory, and then enter the
password, and you can recover. Note that the host recovery will also
restore the slave under the host.
From the machine:
Long press the set key to recover, the page shows the host ID for NULL,
composition power ID on the page will display a letter from the A group
to the D group.
1.3.4 time settings
Host:
You can be set in the settime option for OLED or the PC tool can send
serial instruction settings
1.3.5 Login password settings
The initial password is "0000" press 4 SET to enter the background
management system.
You can also be in OLED password settings or PC tool can send serial
instruction settings
1.4 Description of the PC-terminal serial port communication software
1.4.1 over the PC tool issued instructions to set the time, scroll bar, login
password, etc., through USB to micro data cable, search for serial communication
assistant on the Internet.Host communication hardware chip CH340E,WIN10 system
without mounting drive (serial port port rate: 115200)