User's Manual
Table Of Contents
- Important Safety Instructions
- Safety Instructions for Handset Battery Pack
- Handset and Base Layouts
- Handset and Charger
- LCD Display
- Getting Started
- Features
- Basic Operation
- Answering Calls
- Display for incoming calls:
- Display during an active call
- Display after a call is terminated
- Using the Intercom
- Making External Calls
- Ending your outgoing call
- Teleconference and Intercom Call Transferring
- Call Waiting
- Call Waiting ID
- Redial
- _
- Muting the Handset Microphone
- Page
- Using the ‘Hands-Free’ Handset Speakerphone
- Pay N’ Talk Service (The LDS Key)
- Handset Menu and Programming
- Call Log (Caller ID)
- CALLER ID Prefix
- Smart Dialing
- Phone Book
- Volume
- Ring Volume
- Ring Pattern
- Auto talk
- Low Battery alert Tone
- No coverage alert Tone
- Key Tone
- Key Lock
- Handset Naming
- Language
- LCD Contrast
- Reset Handset
- Default Handset settings
- Base PIN Code
- Base Dial Mode
- Base Flash Timing
- Base CID Prefix
- Base Message Waiting LED
- Resetting the Base
- Default Base setting
- Base Unit Status Indication
- Display Messages
- Registering Your Handsets (Adding Handsets to Your System)
- De-registering Your Handsets (Removing Handsets from Your System)
- Consumer Information
- Limited Warranty
3) This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
This device may not cause harmful interference; and (2) This device must accept any interference received,
including interference that may cause undesired operation.
4) For body worn operation, this handset has been tested and meets the FCC RF exposure guidelines. Use of
accessories may not ensure compliance with FCC RF exposure guidelines.
5)The FCC ID for base of this product is:RAQE30001BBS,for handset is RAQE30001BHS.
Should you experience trouble with this equipment, please contact American Telecom Services Customer Support
for service information. If the equipment is causing harm to the telephone network, the telephone company may
request that you disconnect the equipment until the problem is resolved.
WARNING: Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user's authority to operate the equipment.
CAUTION: To maintain compliance with the FCC's RF exposure guidelines place the base unit at least
20 cm from nearby persons.
CAUTION:
For service or replacement, please contact American Telecom Services Support.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in
a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is needed.
• Consult the dealer or an experienced radio TV technician for help.
American Telecom Customer Support:
1-888-928-7746
6 Concourse Pkwy
Suite 1525
Atlanta, GA 30328
For support with Pay N’ Talk Service, call IDT Customer service 24
hours a day, 7 days a week at 1-888-757-6545.
27