Instructions / Assembly

Nail into the siding using a
galvanized nail with a head
of at least 3/16" and a
length sufficient to penetrate
1" into the corner studs.
1. Start with the bottom course of siding.
Carefully slide the first corner up and under the second
course. Continue until the bottom wrap around lip is
fully fitted to the bottom courses.
2. Continue working from the bottom up. While driving
the nails pay attention to the vertical and horizontal
alignment of the siding corner. Trim the last corner to fit.
Corner Stud
Siding CornerNail
Siding
These installation guidelines are for use with typical or standard applications.
It is always recommended to seek advice from a licensed professional, and
to check with your local building inspector or building permit office for
approvals and possible variations that may apply.
SIDING CORNERS
BASIC INSTALLATION GUIDELINES
#06693
gibraltarbuildingproducts.com