Instructions / Assembly

ManualsBrandsGibraltar Building Products ManualsBuilding materials2-5/8 in. x 1-1/2 in. x 10 ft. Aluminum Eave Drip Flashing in Black

Eave Drip on Rake applied

over underlayment

Eave Drip on Eave applied

directly to the roof deck

Trim and bend

Eave Drip on

corners to form

a box end

GALVANIZED EAVE DRIP

INSTALLATION GUIDELINES

These installation guidelines are for use with typical or standard applications. It is always recommended to seek advice from a licensed professional,

and to check with your local building inspector or building permit office for approvals and possible variations that may apply.

CAUTION!

Working above grade is inherently dangerous, be sure that proper fall protection measures are in place.

When working with power tools and sheet metal, gloves and eye protection are absolutely required.

Begin installation along the eaves, starting at a corner and working your way

around, overlapping each succeeding piece of drip edge by 2-3 inches.

After the eave drip edge has been installed, apply the underlayment and/or

ice-water barrier.

Once the underlayment has been installed, apply the drip edge to the rakes.

Make box corners by wrapping the rake edge around the eave metal.

Depending on local building codes and wind conditions, roof edge should be

nailed every 4 in. - 24 in.

1/32"

Over Driven