Instructions / Assembly

Nail into the siding using a
galvanized nail with a head
of at least 3/16" and a
length sufficient to penetrate
1" into the corner studs.
1. Start with the bottom course of siding.
Carefully slide the first corner up and under the
second course. Continue until the bottom wrap
around lip is fully fitted to the bottom courses.
2. Continue working from the bottom up. While
driving the nails pay attention to the vertical and
horizontal alignment of the siding corner. Trim the
last corner to fit.
Corner Stud
Siding CornerNail
Siding
These installation guidelines are for use with typical or standard
applications. It is always recommended to seek advice from a licensed
professional, and to check with your local building inspector or building
permit office for approvals and possible variations that may apply.
SIDING CORNERS
BASIC INSTALLATION GUIDELINES
2110XL-W