Instructions / Assembly

Roof Deck
INSTALLATION GUIDELINES #98190 & #98191
SM-RIB PANEL CLOSURE STRIPS
These installation guidelines are for use with typical or standard applications. Refer to SM-Rib installation guide for panel and flashing install details.
It is always recommended to seek advice from a licensed professional, and to check with your local building inspector or building permit office for approvals
and possible variations that may apply.
CAUTION!
Working above grade is inherently dangerous, be sure that proper fall protection measures are in place.
When working with power tools and sheet metal, gloves and eye protection are absolutely required.
Start at the eave by positioning a line of butyl tape on the roof edge. Remove the release paper on the tape and gently
embed the foam closure strip.
Install metal roofing panels, fastening through the closure strip with the appropriate amount of fasteners as set out in local
building codes.
When you get to the ridge, apply another line of butyl tape to the roof panel. Remove the elease paper, then embed the
closure strip, just before installing the ridge cap.
SM-Rib Foam Closures have locking tabs at each end for secure joining of lengths.
Ridge Cap
Outside Closure
Roof Panel
Inside
Closure
Butyl
Tape
Butyl Tape
Inside Closure #98190 Outside Closure #98191
Roof Edge

Summary of content (1 pages)