Instructions / Assembly

Measure & Cut
Measure 1/2 inch shorter than the
floor to ceiling distance. Make two
cuts toward the centerline, using tin
snips. Use one continuous length, do
not splice. Trim ends at 45° angle.
Apply Mud
Thin joint compound with water.
Apply a generous, uniform layer
2" on both sides.
Set the bead
Using light, even pressure set the
bead centerd on the corner and
tight to the ceiling.
Top View
Overlapping drywall sheets form the
corner. The feathering of the drywall
joint compound smoothly covers the
nails & corner bead.
Top Coat Mud
Using a 6"- 10" drywall taping knife,
apply a top coat of drywall joint
compound to each side. Feather the
compound 8" - 10" from the corner.
Allow to dry.
6"-10"
Skim Coat
Apply a thinner third coat of drywall
joint compound to each side,
feathered 10" - 12". Allow to dry.
6"-10"
3
4"-5"
Drywall Compound
Framing
1 2
4 5
3
COMPOSITE CORNER BEAD
BASIC INSTALLATION GUIDELINES
#BS3008
#BS30010