Instructions / Assembly

ManualsBrandsGibraltar Building Products ManualsHeating, Venting & CoolingUndereave 16 in. x 8 in. Louvered Aluminum Soffit Vent in Brown (24-Pieces/Carton Only)

FACE ON VENTS

INSTALLATION GUIDELINES

These installation guidelines are for use with typical or standard applications. It is always recommended to seek advice from a licensed professional, and to

check with your local building inspector or building permit office for approvals and possible variations that may apply.

CAUTION! Working above grade is inherently dangerous, be sure that proper fall protection measures are in place.

When working with power tools and sheet metal, gloves and eye protection are absolutely required.

Face On Vents – Used where surface mount venting is needed or to cover openings where original installed vents have

deteriorated. These vents are ideal for use where traditional framing members (studs) are 16 in. on center.

2x4

Stud

2x4

Stud

©©

16 in.

Opening measurements must be at least 1 inch smaller than the vent size.

Remove old vent, if necessary, and clean any loose debris from the opening.

Apply a bead of sealant around inside

of vent ange.

Fasten vent with nails or screws.

2 3

Summary of content (1 pages)

PAGE 1
INSTALLATION GUIDELINES FACE ON VENTS Face On Vents – Used where surface mount venting is needed or to cover openings where original installed vents have deteriorated. These vents are ideal for use where traditional framing members (studs) are 16 in. on center. 1 16 in. © 2x4 Stud © Opening measurements must be at least 1 inch smaller than the vent size. Remove old vent, if necessary, and clean any loose debris from the opening. 2 2x4 Stud 3 Apply a bead of sealant around inside of vent flange.