Instructions / Assembly

ManualsBrandsGibraltar Building Products ManualsBuilding materials1-1/2 in. x 1-1/2 in. x 10 ft. Galvanized Steel Drip Edge Flashing

GALVANIZED ROOF EDGE

INSTALLATION GUIDELINES

These installation guidelines are for use with typical or standard applications. It is always recommended to seek advice from a licensed professional,

and to check with your local building inspector or building permit office for approvals and possible variations that may apply.

CAUTION!

Working above grade is inherently dangerous, be sure that proper fall protection measures are in place.

When working with power tools and sheet metal, gloves and eye protection are absolutely required.

Begin installation along the eaves, starting at a corner and working your way

around, overlapping each succeeding piece of drip edge by 2-3 inches.

After the eave drip edge has been installed, apply the underlayment and/or

ice-water barrier.

Once the underlayment has been installed, apply the drip edge to the rakes. Make

box corners by wrapping the rake edge around the eave metal.

Depending on local building codes and wind conditions, roof edge should be

nailed every 4 in. - 24 in.

PRE-DRILL HOLES

EAVE

RAKE

ROOF EDGE ROOF EDGE

1/32"

Over Driven