Instructions / Assembly

ManualsBrandsGibraltar Building Products ManualsBuilding materials14 in. x 6 in. Bonderized Steel Vulcan Foundation Vent

VULCAN FOUNDATION VENTS

INSTALLATION GUIDELINES #VFS614FFB

These installation guidelines are for use with typical or standard applications. It is always recommended to seek advice from a licensed professional,

and to check with your local building inspector or building permit office for approvals and possible variations that may apply.

1. Remove old vent and any loose debris from opening. 2. Apply a bead of sealant to the vent ange or wall.

3. Using the partial punched corner fastener guides (4 per vent),

fasten vent with nails or screws.

6 ⁄ in.

16.83 cm

5 ½ in.

13.97 cm

END ELEVATION

14 ¾ in.

37.47 cm

13 ½ in.

34.29 cm

SIDE ELEVATION

The vent with built-in fire suppression

Summary of content (2 pages)

PAGE 1
INSTALLATION GUIDELINES #VFS614FFB VULCAN FOUNDATION VENTS 1 1. Remove old vent and any loose debris from opening. 2 2. Apply a bead of sealant to the vent flange or wall. 3 14 ¾ in. 37.47 cm 13 ½ in. 34.29 cm SIDE ELEVATION 3. Using the partial punched corner fastener guides (4 per vent), fasten vent with nails or screws. 6 5⁄8 in. 16.83 cm 5 ½ in. 13.97 cm END ELEVATION The vent with built-in fire suppression These installation guidelines are for use with typical or standard applications.
PAGE 2
#VFS614FFB INSTALLATION GUIDELINES VULCAN SOFFIT VENTS With intumescent coating that closes at high temps and ember catching mesh, this fire-resistant design will protect your property from embers and flame intrusion into the attic. 1 1. From inside the attic locate the area between the soffit joists where you will be installing the soffit vents. Find the center and then drill a hole to mark it. 2 2. On the outside of your home, snap a chalkline to indicate the center of the soffit area.