Instructions / Assembly

VULCAN SOFFIT VENTS
INSTALLATION GUIDELINES
#VFS614FFB
1. From inside the attic locate the area between the soffit
joists where you will be installing the soffit vents. Find the
center and then drill a hole to mark it.
2. On the outside of your home, snap a chalkline to indicate
the center of the soffit area. Draw a rectangle that is 13-1/2
inches x 5-1/2 inches. Cut with a jigsaw or reciprocating saw.
4. Install the vent by inserting it into the opening. Nail into
place with galvanized nails.
With intumescent coating that closes at high temps and ember catching mesh, this fire-resistant design will protect
your property from embers and flame intrusion into the attic.
These installation guidelines are for use with typical or standard applications. It is always recommended to seek advice from a licensed professional,
and to check with your local building inspector or building permit office for approvals and possible variations that may apply.
1
2
3
6 ⁄ in.
16.83 cm
5 ½ in.
13.97 cm
END ELEVATION
14 ¾ in.
37.47 cm
13 ½ in.
34.29 cm
SIDE ELEVATION
The vent with built-in fire suppression