Instructions / Assembly

ASSEMBLY INSTRUCTIONS FOR THE SAVANNAH™ POST

Tools required to assemble mailbox: Phillips Screwdriver and Crescent Wrench or Pliers

1. Post Assembly

Fit Upper Post Section into Lower Post Section (Fig.1).

Press down until the connection is tight.

2. Mounting Hardware

Using two Washers (A), two 1-1/4” Screws (C) and two 3/8”

Locking Nuts (B), Attach the two Mailbox Mounting Brackets (E)

to the top of the Post Assembly as shown in Fig.2 & Fig.3.

3. Placing Post in Ground

The condition of the soil where you desire to place your Mailbox

Post will determine the method to use. If the soil is soft

you can use the method shown in Fig.4 or Fig.5. If the soil is

hard or compacted you may need to dig a hole. For the most

secure and permanent installation you should dig a hole and

set the post in concrete. Check with your local Postmaster to

find out the required height your mailbox must be above the

road surface.

4. Mounting Mailbox

After the Post is secure in the ground attach your mailbox using

four Washers (A), four 5/8” Screws (D) and four 3/8” Locking

Nuts (B). These will work on most all #1 size rural boxes. For

larger mailboxes you will need to use longer screws (not includ-

ed).

Read instructions before proceeding with assembly. Check parts list to be sure all parts and hardware are included.

OSTAL PATRONS ARE REQUIRED TO CONTACT THE LOCAL POST OFFICE BEFORE INSTALLING THE MAILBOX TO ENSURE ITS CORRECT PLACEMENT AND HEIGHT FROM THE

TREET. GENERALLY, MAILBOXES ARE INSTALLED AT A HEIGHT OF 41-45 INCHES FROM THE ROAD SURFACE TO INSIDE FLOOR OF THE MAILBOX AND ARE SET BACK 6-8 INCH-

ES FROM THE FRONT FACE OF CURB OR ROAD EDGE TO THE MAILBOX DOOR..

HARDWARE PACK INCLUDES:

A. 1/2” Washer (6)

B. 3/8” Locking Nut (6)

C. 1-1/4” Phillips Head Screw (6)

D. 5/8” Phillips Head Screw (4)

E. Mailbox Mounting Bracket (2)

2 Post Parts

2007

Fig.1

Fig.2

Fig.3

Fig.4

Fig.5

PostMaster logo is a trademark of Gibraltar Industries.

Manufactured by Home Impressions, a Gibraltar Industries company, Taylorsville, MS 39168