Instructions / Assembly

ManualsBrandsGibraltar Mailboxes ManualsHardwareGibraltar Stanley (ST200000) Post Mount Jumbo Mailbox, Galvanized Steel - Silver Gray

PLASTIC HARDWARE ASSEMBLY INSTRUCTIONS

Instructions

1. Place and hold gasket (B) over the shaped slots in top of mailbox as in diagram.

Insert top latch (A) through matching shaped slots in gasket and top of mailbox

and secure with wedge clip (C). See figure 2.

2. Insert door latch (D) through holes in front of door. Secure with latch clip (E).

3. Insert flag (G) in bracket (F) and align with holes in mailbox. With bracket locator pins

inside same patterned mailbox holes, press push pin (I) firmly into mailbox.

Secure with pin clip (H).

4. Mailbox is now ready for installation on post.

Fig. 1

Fig. 2

NOTE: CUSTOMERS ARE REQUIRED TO CONTACT THE LOCAL POST OFFICE BEFORE INSTALLING

THE MAILBOX TO ENSURE ITS CORRECT PLACEMENT AND HEIGHT AT THE STREET.

GENERALLY, MAILBOXES ARE INSTALLED AT A HEIGHT OF 41-45 IN. FROM THE ROAD SURFACE

TO INSIDE FLOOR OF THE MAILBOX OR POINT OF MAIL ENTRY (LOCKED DESIGNS) AND ARE

SET BACK 6-8 IN. FROM FRONT FACE OF CURB OR ROAD EDGE TO THE MAILBOX DOOR.

Taylorsville, MS 39168

CONTENTS

TOP LATCH

GASKET

WEDGE

CLIP

DOOR

LATCH

CLIP

FLAG

BRACKET

RED FLAG

PIN CLIP

PUSH PIN

THIS PART

NOT USED

Summary of content (3 pages)

PAGE 1
PLASTIC HARDWARE ASSEMBLY INSTRUCTIONS A CONTENTS A Fig. 2 TOP LATCH B Fig. 1 E LATCH CLIP B GASKET H C D DOOR LATCH F FLAG BRACKET H I WEDGE CLIP PIN CLIP RED FLAG D E G F PUSH PIN THIS PART NOT USED G C I Instructions 1. Place and hold gasket (B) over the shaped slots in top of mailbox as in diagram. Insert top latch (A) through matching shaped slots in gasket and top of mailbox and secure with wedge clip (C). See figure 2. 2. Insert door latch (D) through holes in front of door.
PAGE 2
Instructions 1. Placer et immobiliser le joint d'étanchéité (B) sur les rainures du dessus de la boîte aux lettres, tel qu'illustré. Insérer le verrou supérieur (A) dans les rainures correspondantes du joint et du dessus de la boîte, puis fixer en place avec la pincecale (C). Voir la Figure 2. 2. Insérer le verrou de porte (D) dans les trous à l'avant de la porte. Fixer en place avec la pince de verrou (E). 3. Insérer le drapeau (G) dans l'attache (F), puis aligner avec les trous de la boîte aux lettres.
PAGE 3
Care and Maintenance / Cuidado y mantenimiento This mailbox is protected by the finest rust resistant powder coat paint in the industry. With a minimum amount of maintenance, your mailbox can look like new for a longer period of time. Like any outdoor product made of steel, surface rust may appear over time depending on its placement or environmental conditions. Wipe any surface rust with a steel wool pad and clean with a damp cloth and household detergent occasionally.