Installation guide

ManualsBrandsGibson ManualsRoom air conditionerOfficial Gibson air conditioner

u m

READ BEFORE iNSTALLING UNIT

MS niWindow Mounting

Your ah"conditioner is desigl_ed to install in skmdard

double lumg windows with opening widths ol 22 to 36

inches (559 mm to 914 ram) (FIG. l)

Lower sash must open suificiemly to allow a clear vertical

opening of 14-1/2 inches (368 ram). Side louvers and the

rear of the AC must have clear air space to allow

enough airllow through the condensel; hn" heat removal.

The rear of the unit must be outdoors, not inside a

building or garage°

When handling unit, be careful to avoid cuts

f?om sharp metal edges and aluminum fins on

front and rear coils.

Beibre installing unit, the top rail must be

assembled on the unit.

_lbp Rail Hardware Qty.

3/8" Screw 4

Top Rail 1

NOTE: SAVE CARTON and these INSTALLA-

TiON iNSTRUCTiONS fin:fmnre reference. The caJlon is

the best way to store unit during wimer, or when not h_use.

Some assemNy is required. Please read these instructions

Mounting Hardware

3/4 'screws

lock frame

sash lock

TOOLS NEEDED:

• Drill (if pik)t hales are needed)

Qty.

TOOL NEEDED:

* PhilBips Screwdriver

A. Remove the air

conditioner flTomthe

cmlon and place on a

flat surface.

B. Remove top rail from

tlle bottom of the

packaging material as

shown in Fig. A

C. Align the hole in the

the top of the unit as

shown in Fig. B

D. Secure the top raiI to

rite unit with the 3/8"

Screws as shown in

Fig. (7

Packagitlg .

Top Rail

Fig. A

NOTE: FOR SAFETY REASONS, ALL

FOUR (4) SCREWS MUST BE SECURELY

FASTENED.

Summary of content (3 pages)

PAGE 1
u m READ BEFORE iNSTALLING UNIT MS ni Window Mounting Your ah"conditioner is desigl_ed to install in skmdard double lumg windows with opening widths ol 22 to 36 inches (559 mm to 914 ram) (FIG. l) Lower sash must open suificiemly to allow a clear vertical opening of 14-1/2 inches (368 ram). Side louvers and the rear of the AC must have clear air space to allow enough airllow through the condensel; hn" heat removal.
PAGE 2
How to Install NOTE: Top Rail o_gset to provide This is necessary and drainage. If any reason, this and Sliding the proper for proper you are not pitch to the Panels at each side are pitch to the rear of (5/16").
PAGE 3
Place the fi°ame lock between the fl°ame extensions and the window sill as shown Cut _i)am seal and insert in the space between the upper and lower sashes (FIG. 13). (Fig. 8). Drive 3/4" (19 ram) locking screws through the frame tock and into the sill (FIG. 9). NOTE: '[b prevent window sill from splitting, drill 1/8" (3 ram) pilot holes before driving screws. IfAC is Blocked by Storm Add wood as shown in FIG. 14, or remove window be_i)re ah: conditioner is installed.