Installation guide

ManualsBrandsGibson ManualsRoom air conditionerOfficial Gibson air conditioner

|nstailation instruct"

READ BEFORE iNSTALLiNG UNiT

Compact ii Window Mounting

Your air conditioner is designed to install in standard

double hung windows with opening widths of 23 to 36

inches (584 mm to 914 mm) (FIG. 1)

Lower sash must open sufficiently to allow- a clear vertical

opening of 14-1/2 inches (368 ram). Side louvers and the

rear of the AC must have clear air space to allow

enough airflow through the condensel; for heat removal.

The rear of the unit must be outdoors, not inside a

building or garage.

/ x'

NOTE: SAVE CARTON and these ][NSTALLATI()N

INSTRUCTIONS for furore reference. The carton is the

best way to store unit during winter, or when not in use.

Some assembly is required. Please read these instructions

carefully.

When handling unit, be careful to avoid cuts

from sharp metal edges and aluminum fins on

front and rear coils.

Before installing the unit, the Left-Hand

Louver must be assembled to the unit:

A. Carefully remove power supply

coM from air discharge area

(Fig. A).

B. Carefully remove the Left-Hired

Louver Assembly from the

discharge area, and then remove

it from the plastic bag(Fig. B).

C. With care, pry apart the auger

wheel shaft from the horizontal

louver casing, as shown in Fig.

C,D&E.

Mounting Hardware

3/4"screws

lock flame

sash lock

TOOLS NEEDED:

, Phillips Screw Driver

* Drill (If pilot holes am needed)

Qty.

D. Now locate the auger wheel

shaft into the vertical center

post (Fig. F).

E. Clip the other end into the

locating slot.

E Now place the horizontal louver

casing onto the auger wheel

shaft, and snap in place (Fig.

G).

Check the operation by moving

the horizontal louver up and

down, and then turn the auger wheel so the vertical

louvers rotate.

1 cominstallen06

Summary of content (3 pages)

PAGE 1
|nstailation instruct" READ BEFORE iNSTALLiNG UNiT Compact ii Window Mounting Your air conditioner is designed to install in standard double hung windows with opening widths of 23 to 36 inches (584 mm to 914 mm) (FIG. 1) When handling from sharp metal edges and aluminum front and rear coils. Lower sash must open sufficiently to allow- a clear vertical opening of 14-1/2 inches (368 ram).
PAGE 2
÷ How to Install NOTE: Top Rail offset to provide This is necessary and drainage. If any reason, this and Sliding the proper for proper you are not pitch to the Panels at each side are pitch to the rear of (5/16"). condensed water utilization using the Side Panels for rear must be maintained! Place unit on floor, a bench or a table. There is a Left and Right Windnw Filler Ptmel - be sure to use the proper panel for each side.
PAGE 3
Place the frame lock between tile fi°ame extensions and the window sill as shown (Fig. 8). Drive 3/4" screws through tile frame (FIG. 9). NOTE: To prevent splitting, drill 1/8" (3 ram) driving screws. Cut foam seal and insert in the space between tile upper and lower sashes (FIG. 13). (19 ram) locking lock and into the sill window sill from pilot holes before IfAC is Blocked Window by Storm Add wood as shown in FIG. 14, or remove storm window before air conditioner is installed.