Installation guide

NOTE:ffwall thicknessis8-1/2"ormore,addalulninum
flashingoverbottomofframeopeningtoassurenowatercan
enterareabetweeninnerandouterwall.
1" LONG
WOOD SCREW
FIG. 2
ALUMINUM FLASHING
OVER BOTTOM OF FRAME
OVER
81/2"
Prepare and Install
Cabinet
Refer to Step 4 of Window Momlting for assembly of support
brackets. A wooden strip nailed to the outside wall should be
used in conjtmction with sill support angle brackets.
1. Slide chassis from cabinet. Refer back to Step 1 of
Window Mounting
2. Place cabinet into opening with bottom rail resting firmly
oll bottom board of wooden frame.
3. Position cabinet to achieve proper slope for water removal.
(See FIG 1 below.)
FIG. 1
5/16"--
TO
318"
LEVEL
314" PLUS
TRIM THICKNESS
SEE PARA 5
e
Wooden strip
5. Screw or nail cabinet wooden frame using shims if frame
is oversized, to eliminate distortion. Remember to maintain
proper slope as described in Step 3.
4. Secure bottom rail to wood frame with two large wood
screws 1"(2.5 cm) long using the two holes in the bottom
of the channel resting on frame. (See FIG. 2 following)
6. Install chassis into cabinet by following all steps in Step
8 of Window Momlting. (continued)