Installation guide

Window Mounting
1,
2.
Remove Chassis
Pull down front panel and remove filter. (See FIG. 1).
Lift front upwards and place to one side.
IL! Install Top Angle
mm
and Side Bracket
1. Attach foam gasket to top angle above holes as
shown in FIG. 6.
3, Locate the four front screws and remove. These screw's will
be needed to re-install the front later. (See FIG: 2).
4. Pry away front from cabinet sides as per photo (See FIG. 3).
51 Gently lift front offunit and place to one side (See FIG. 4).
2, Install top
angle and
side retainers
to cabinet as
shown in FIG. 6.
FIG. 6
6. Remove shipping crews from top &unit and also on the side
by the base if installed.
7. Hold the cabinet while pulling on the base handle, and care-
fillly remove the unit.
8. Addtwo foam inserts t,oholes in top of cabinet where
shipping screws were removed from.
Assemble Window
Filler Panels
1. Place cabinet on floor, a bench, or a table.
2. Slide "I" section of window filler panel into side retainer
on the side of the cabinet (see Figures 7-8). Do both
sides.
FIG. 7
PLASTIC V_NDOW FILLER
FRAME PANEL
9,
Your unit may come with internal packaging. THIS
PACKAGING MUST BE REMOVED PRIOR TO
INSTALLING THE AIR CONDITIONER BACK
INTO THE CABINET. (See FIG. 5).
FIG, 8
SIDE
RETAINER
AIR CO_ioNER
PLASTIC
FRAME
"1" SECTION
WINDOW HOLE
FILLER
PANEL