Installation guide

How to Install
NOTE: Top Rail and Sliding Panels at each side are
o_gset to provide the proper pitch to the rear of (5/16").
This is necessary for proper condensed water utilization
and drainage. If you are not using the Side Panels for
any reason, this pitch to the rear must be maintained!
Place unit on floor, a bench or a table, There is a
Left and Right Window Filler Panel - be sure to
use the proper panel _i_reach side,When installed
the []ange [or securhlg the panel hi place to the window sill
will be [)acing into the morn,
A. Hold file
Accordion
Pane] in one
hand and
geJlt]y pull
back the
center to }]ee
the open end.
See Figure 2.
C, Once the panel
has been
hlstaHed on the
side of the
cabinet, make
sure it sits
file [rame
making Might
adjustments. SHde the top and bottom ends of the [tame
into the top and bottom rails of file cabinet. Figure 5.
D. Slide the panel aH the way hi and repeat on the oilier
side.
NOTE" If storm window blocks AC, see FIG, 12,
Keep a firm grip on the air conditioner, carefully
place file unit into the window opening so the
bottom of the ai r conditioner }rame is against the
window sill (FIG.
6). Carefully close
the window behind
the top rail of the
unit,
B, Slide the fl:ee end (I"section) of the panel hlto the
cabinet as shown in Figures 3A, 3B & 4_ SHde the
panel down. Be sure to leave el_ough space to sJip the
top and bottom of the fl'ame into the mils on the cabinet.
ExteJld the side pands out against the window
h:arne(FIG, 7),