Manual

First Steps
4.
5,
i: :: I¸ i: ¸
i¸ ® -- i:::
(2) C
bolts
lock nut _,/ Install caster
x
screws
Swivel caster ;
Figure 5
Repeat the same procedure for the
opposite rear corner.
With the help of an assistant, carefully
upright the unit. Reassemble the rear
access guard with screws.
Unitwi!!to!!forwardas itistipped
up,
Appliance Placement
Leave a 1" space on all sides and the back of
the cabinet for ease of installation, proper air
circulation and electrical connections. DO NOT
block the front grill on the lower front of your
appliance. Sufficient air circulation is essential
for the proper operation of your appliance.
Choose a place that is near a grounded electrical
outlet. For the most efficient operation, the
appliance should be located where surrounding
temperatures will not drop below 40OF (5oC)
or exceed 110OF (43oc). Additional compressor
heaters are not recommended.
Insulation
The insulated space of this cabinet is sealed
to maintain peak efficiency. Holes drilled in
the cabinet may destroy that seal and damage
electrical wiring located in the insulated space.
DAHAGED ELECTRICAL WIRING OR WET
INSULATION CAUSED BY DRILLING WILL
VOID THE WARRANTY,
Reversing Door
This appliance features a door that can provide
either left hand or right hand opening. It comes
from the factory with right hand position.
Follow these steps to reverse the opening:
1. With the appliance in a standing upright
position, open the door and remove the
toe plate (2 screws in the upper corners).
2. Slightly loosen the 2 hex spacers that the
5
3.
4.
toe plate screws were screwed into.
(2_He× Head ,-.,_
(2)Screws.............................._ 4
To&_Plate _a_i_
Holding door securely closed; remove 2
hex head screws from the top hinge.
Lift appliance door off of bottom hinge
and set aside in a safe place so it does
not fall.
_,_..(2) HexHead Screws
TopHinge
-- Cabinet
5. Remove top screws from bottom hinge.
Remove top screw from opposite side
of appliance.
6.
Slide bottom hinge onto hex spacer and
attach top screw to cabinet. Retighten
both hex spacers.
8crew ...........................
ooooo ,,
7,
8.
_en_d)
Remove top hinge assembly from the door
and reverse the position making sure the
pegs are properly seated in the peg holes.
Rotate the door 180 ° and re-install on
bottom hinge. Hold door in closed position.
9. Rotate the top hinge to align the
mounting holes. Reposition the hinge to