GNFJ60JGUW Cooker User Manual
Contents Safety information Safety instructions Product description Before first use Hob - Daily use Hob - Hints and tips Hob - Care and cleaning 2 4 7 7 8 9 9 Oven - Daily use Oven - Using the accessories Oven - Hints and tips Oven - Care and cleaning Troubleshooting Installation 10 11 11 14 16 17 Subject to change without notice. Safety information Before the installation and use of the appliance, carefully read the supplied instructions.
General Safety • • • • • • • • • • • • • • • • Only a qualified person must install this appliance and replace the cable. This appliance is intended for use up to an altitude of 2000 m above sea level. This appliance is not intended to be used on a ships, boats or vessels. Do not install the appliance behind a decorative door in order to avoid overheating. Do not install the appliance on a platform. Do not operate the appliance by means of an external timer or separate remote-control system.
• • • Ensure that the appliance is switched off before replacing the lamp to avoid the possibility of electric shock. If the mains power supply cable is damaged, it must be replaced by the manufacturer, its Authorised Service Centre or similarly qualified persons to avoid an electrical hazard.
• • The electrical installation must have an isolation device which lets you disconnect the appliance from the mains at all poles. The isolation device must have a contact opening width of minimum 3 mm. Fully close the appliance door, before you connect the mains plug to the mains socket. Gas connection • • • • • All gas connections should be made by a qualified person.
• • • • Make sure the flame does not go out when you quickly turn the knob from the maximum to the minimum position. Use only the accessories supplied with the appliance. Do not install a flame diffuser on the burner. This appliance is for cooking purposes only. It must not be used for other purposes, for example room heating. Care and Cleaning WARNING! Risk of injury, fire, or damage to the appliance. • • • • • • • • • 6 Before maintenance, deactivate the appliance.
Product description General overview 1 2 3 4 7 5 6 5 4 3 2 1 1 2 3 4 5 6 7 Knob for the grill Knob for the heating functions Button for the lamp Knobs for the hob Grill Lamp Shelf positions Cooking surface layout 1 2 5 3 4 Accessories • 1 Auxiliary burner 2 Steam outlet - number and position depend on the model 3 Semi-rapid burner 4 Semi-rapid burner 5 Rapid burner For cookware, cake tins, roasts. Wire shelf Before first use WARNING! Refer to Safety chapters.
Preheating Preheat the empty appliance to burn off the remaining grease. 1. Set the maximum temperature. 2. Let the appliance operate for approximately 1 hour. The appliance can emit an odour and smoke. This is normal. Make sure that the airflow is sufficient. Let the oven cool down. Dampen a soft cloth with warm water and a little mild washing-up liquid and use this to clean the oven cavity. 3. Set the function to position and the maximum temperature. 4. Let the appliance operate for 15 minutes.
WARNING! Always turn the flame down or switch it off before you remove the pans from the burner. Hob - Hints and tips WARNING! Diameters of cookware Refer to Safety chapters. WARNING! Use cookware with diameters applicable to the size of burners. Cookware WARNING! Do not put the same pan on two burners. WARNING! Do not put unstable or damaged pots on the burner to prevent spills and injuries.
Be very careful when you replace the pan supports to prevent the hob top from damage. 2. The enamel coating occasionally can have rough edges, so be careful when you wash the pan supports by hand and dry them. If necessary, remove stubborn stains with a paste cleaner. 3. After you clean the pan supports, make sure that they are in correct positions. 4. For the burner to operate correctly, make sure that the arms of the pan supports are aligned with the centre of the burner.
After igniting the oven gas burner 1. Release the knob for the oven functions. 2. Close the oven door. 3. Turn the knob for the oven functions to set the necessary heat setting. Control the flame trough the holes in the bottom of the oven. Turning off the oven burner To put out the flame, turn the knob to the off position . Grilling WARNING! Always cook with the oven door closed. We recommend that you do not use the electric grill for cooking at the same time as the gas oven. 1.
General information • • • • The appliance has five shelf positions. Count the shelf positions from the bottom of the appliance floor. Moisture can condense in the appliance or on the door glass panels. This is normal. Always stand back from the appliance when you open the appliance door while cooking. To decrease the condensation, operate the appliance for 10 minutes before cooking. Clean the moisture after each use of the appliance.
Meat Food Quanti‐ ty (kg) Temper‐ ature (°C) Pre‐ heat‐ ing time (min) Time (min) Grill po‐ si‐ tion Grill‐ ing time (min) Total prepa‐ ration time (min) Shelf posi‐ tion Sheep 1.5 - 2.0 180 - 200 10 80 - 100 on last 5 80 - 100 2 Chicken 1.2 - 1.8 210 - 240 10 100 - 110 on last 5 100 110 2 Duck 1.8 - 2.5 180 - 200 10 90 - 110 on last 5 90 - 110 2 Goose 2.5 - 3.0 170 - 190 10 90 - 100 on last 5 90 - 100 2 Rabbit 1.0 - 1.
Cakes Food Quanti‐ ty (kg) Temper‐ ature (°C) Pre‐ heat‐ ing time (min) Time (min) Grill po‐ si‐ tion Grill‐ ing time (min) Total prep‐ ara‐ tion time (min) Shelf posi‐ tion Biscuits 0.2 - 0.5 180 - 190 10 15 - 20 on last 5 15 - 20 3 Flat cake 0.6 - 1.0 170 - 190 10 25 - 30 on last 5 25 - 30 2 Orange cake 1.0 - 1.5 150 - 180 10 110 - 115 on last 5 110 115 2 Feter Mshal‐ ted 1.0 - 1.5 190 - 210 10 40 - 50 on last 5 40 - 50 2 Salty cake 1.0 - 1.
Stainless steel or aluminium ovens Clean the oven door with a damp cloth or sponge only. Dry it with a soft cloth. Do not use steel wool, acids or abrasive materials as they can damage the oven surface. Clean the oven control panel with the same precautions. Cleaning the oven door The oven door has two panels of glass installed one behind the other. To make the cleaning easier remove the oven door.
against the top edge of the door. Lift the inner door. Replacing the lamp WARNING! Risk of electric shock. The lamp can be hot. 3 2 1. Turn off the oven. Wait until the oven is cooled down. 2. Disconnect the oven from the mains. 3. Put a cloth on the bottom of the cavity. 2 The back lamp 7. Clean the oven door with water and soap. Clean inner side of the door. Dry the oven door carefully. When the cleaning is completed, install the glass panels and the oven door.
Problem Possible cause Remedy The flame ring is uneven. Burner crown is blocked with food residues. Make sure that the injector is not blocked and the burner crown is clean. The burners do not work. There is no gas supply. Check the gas connection. The appliance makes noises. Some metal parts of the appli‐ ance expand and contract when they heat up or cool down. The noises are normal. The flame colour is orange or yellow. The flame can look orange or yellow in some areas of the burner.
Dimension mm D 20 B C Technical data A D D Voltage 220 - 240 V Frequency 50 - 60 Hz Appliance class 1 Minimum distances Dimension Dimension mm mm A 400 Height 850 - 870 B 650 Width 600 C 150 Depth 600 Other technical data Appliance category: I3B/P LPG: G30 (3B/P) 50 mbar Bypass diameters BURNER Ø BYPASS 1/100 mm Auxiliary 26 / 25 Semi-rapid 28 / 29 Rapid 38 / 35 Oven 44 Gas burners for LPG G30 50 mbar BURNER NORMAL POWER kW GAS RATE g/h REDUCED POWER kW INJECT
Gas connection WARNING! Use this appliance with the LPG supply at a pressure of 50 mbar. If you supply the appliance with a lower pressure, the performance of the appliance will be not satisfactory. The gas pipe in the appliance has two endings. You can connect the gas supply to either one of them. The pipe that is not used must be clogged with the pipe closer, which added to the appliance. Use a fixed connections or use a flexible stainless steel pipes in compliance with the regulation in force.
3. With a thin and flat screwdriver adjust the bypass screw A. The model determines the position of the bypass screw A. A B 3. If the floor is not equally flat, use the adjustable feet on the bottom of the appliance to set a stable position for the appliance. Levelling CAUTION! Remove all the accessories from the oven. 1. Disassemble the pan supports and all the burner assemblies. To install all the accessories, do the first step in an opposite sequence.
the space between the cupboards. If the space between the bench cupboards is larger than the width of the appliance, you must adjust the side measurement to centre the appliance. If you changed the dimensions of the cooker, you must align the nontip device correctly. CAUTION! If the space between the bench cupboards is larger than the width of the appliance, you must adjust the side measurement to the centre of the appliance.
Made in Egypt 867342034-B-462018
