User manual

Preheating
Preheat the empty appliance to burn off the
remaining grease.
1. Set the maximum temperature.
2. Let the appliance operate for
approximately 1 hour.
3. Set the function to position and the
maximum temperature.
4. Let the appliance operate for 15 minutes.
WARNING!
Accessories can become hotter
than usual.
The appliance can emit an odour and smoke.
This is normal. Make sure that the airflow is
sufficient.
Let the oven cool down. Dampen a soft cloth
with warm water and a little mild washing-up
liquid and use this to clean the oven cavity.
Hob - Daily use
WARNING!
Refer to Safety chapters.
Ignition of the hob burner
Always light the burner before you
put on the cookware.
WARNING!
Be very careful when you use open
fire in the kitchen environment. The
manufacturer declines any
responsibility in case of the flame
misuse.
Ignition of a hob burner with the
thermocouple
• For manual ignition put the flame near the
burner. Push the knob for the hob down
and turn it counterclockwise to the
maximum gas flow position .
Keep the knob for the hob pushed for equal or
less than 10 seconds to let the thermocouple
warm up. If not, the gas supply is interrupted.
Adjust the flame after it is regular.
WARNING!
Do not keep the knob pushed for
more than 15 seconds. If the
burner does not light after 15
seconds, release the knob, turn it
into the off position and try to light
the burner again after minimum 1
minute.
If after some tries the burner does
not light, check if the crown and its
cap are in the correct position.
If the burner accidentally goes out,
turn the knob to the off position
and try to light the burner again
after minimum 1 minute.
Burner overview
A
B
C
A. Burner cap
B. Burner crown
C. Thermocouple (if applicable)
Turning the burner off
To put the flame out, turn the knob to the off
position .
8