GNGJ90JGVC Cooker User Manual
Contents Safety information Safety instructions Product description Before first use Hob - Daily use Hob - Hints and tips Hob - Care and cleaning 2 4 7 7 8 9 10 Oven - Daily use Oven - Clock functions Oven - Using the accessories Oven - Hints and tips Oven - Care and cleaning Troubleshooting Installation 10 12 12 14 17 20 21 Subject to change without notice. Safety information Before the installation and use of the appliance, carefully read the supplied instructions.
General Safety • • • • • • • • • • • • • • • • Only a qualified person must install this appliance and replace the cable. This appliance is intended for use up to an altitude of 2000 m above sea level. This appliance is not intended to be used on a ships, boats or vessels. Do not install the appliance behind a decorative door in order to avoid overheating. Do not install the appliance on a platform. Do not operate the appliance by means of an external timer or separate remote-control system.
• • • • Before maintenance cut the power supply. Ensure that the appliance is switched off before replacing the lamp to avoid the possibility of electric shock. If the mains power supply cable is damaged, it must be replaced by the manufacturer, its Authorised Service Centre or similarly qualified persons to avoid an electrical hazard.
• the appliance from the mains at all poles. The isolation device must have a contact opening width of minimum 3 mm. Fully close the appliance door, before you connect the mains plug to the mains socket. Gas connection • • • • • All gas connections should be made by a qualified person. Before installation, make sure that the local distribution conditions (nature of the gas and gas pressure) and the adjustment of the appliance are compatible. Make sure that there is air circulation around the appliance.
• • • Use only the accessories supplied with the appliance. Do not install a flame diffuser on the burner. This appliance is for cooking purposes only. It must not be used for other purposes, for example room heating. • Care and Cleaning WARNING! Internal lighting Risk of injury, fire, or damage to the appliance. • • • • • • • • • • Before maintenance, deactivate the appliance. Disconnect the mains plug from the mains socket. Make sure the appliance is cold.
• Flat the external gas pipes.
Clean the oven and the accessories before first use. Put the accessories back to their initial position. Preheating Preheat the empty appliance to burn off the remaining grease. 1. Set the oven function knob to maximum gas flow position . Refer to "Oven - Daily use" chapter. 2. Let the appliance operate for approximately 1 hour. WARNING! Accessories can become hotter than usual. The appliance can emit an odour and smoke. This is normal. Make sure that the airflow is sufficient. Let the oven cool down.
Burner overview A. B. C. D. A Burner cap Burner crown Ignition candle Thermocouple (if applicable) Turning the burner off To put the flame out, turn the knob to the off B C D position . WARNING! Always turn the flame down or switch it off before you remove the pans from the burner. A B C D Hob - Hints and tips WARNING! Refer to Safety chapters. Cookware WARNING! Do not put the same pan on two burners.
Burner Diameter of cook‐ ware (mm) Triple Crown 160 - 260 Rapid 160 - 240 Semi-rapid 140 - 240 Burner Auxiliary Diameter of cook‐ ware (mm) 120 - 180 Energy saving • • If it is possible, always put the lids on the cookware. When the liquid starts to boil, turn down the flame to barely simmer the liquid. Hob - Care and cleaning WARNING! Refer to Safety chapters. General information • • • • • Clean the hob after each use. Always use cookware with a clean base.
Oven Functions Oven function Application Off position The oven is off. Grilling To grill flat food in the middle of the grill. To make toast. Oven lamp To illuminate the oven interior. To use this function, press the button for the lamp and turnspit. Ignition of the oven gas burner CAUTION! When turning on the oven burner the oven door must be opened. CAUTION! Make sure that the lid is opened. When using the oven the lid has to be opened to avoid over-heating.
MAX 3. MIN 4. Turning off the oven burner To put out the flame, turn the knob to the off position . Using the grill CAUTION! Always keep the appliance door closed when the grill operates. Do not put the meat directly on the tray or pan. CAUTION! Do not put the meat on the highest shelf level. There is a risk of fire. 1. Open the oven door. 2. Ignite the grill burner. • For manual ignition hold a flame near the grill burner holes. Push and turn 5. 6. 7. the knob for the grill to the flame position.
Put the shelf on the correct shelf position. Make sure it does not touch the back wall of the oven. A B C WARNING! The maximum weight permitted on the oven shelf is 24 kg. Avoid putting heavier food on the shelf. Tray: Do not push the baking tray all the way to the back wall of the cavity. This prevents the heat from circulating around the tray. The food may be burnt, especially in the rear part of the tray. Put the tray or deep pan on the shelf position.
7. Put the tip of the spit into the turnspit hole. Refer to "Product description" chapter. 8. Put the front part of the spit on the support hook. 9. Remove the turnspit handle. 10. Light the grill. Refer to "Oven - Daily use" chapter. 6. Use the screws to tighten the forks. 11. Press the turnspit button . 12. Make sure that turnspit rotates. 13. Close the oven door. The turnspit does not stop if you open the oven door. When meat is ready press the turnspit button. Turn off the grill.
Cooking tables Take care while using the oven and grill burners simultaneously. The grill burner can only work during the first 45 minutes of the cooking time. Casseroles Food Lasagna Quantity (kg) Oven set‐ ting Pre‐ heat‐ ing time (min) Time (min) Grill posi‐ tion Grilling time (min) Total prepara‐ tion time (min) Shelf posi‐ tion 1.5 - 2.5 max. 10 40 - 50 min. 10 40 - 50 3 Cannelloni 1.5 - 2.5 max. 10 40 - 50 min. 10 40 - 50 3 Potato gratin 1.5 - 2.5 max. 10 75 - 85 min.
Fish Food Quantity (kg) Oven set‐ ting Pre‐ heat‐ ing time (min) Time (min) Grill posi‐ tion Grilling time (min) Total prepara‐ tion time (min) Shelf posi‐ tion Pike 0.8 - 1.5 max. 10 50 - 60 min. 50 - 60 50 - 60 3 Dorade 0.4 - 0.7 max. 10 35 - 40 min. 35 - 40 35 - 40 3 Trout 0.5 - 1.0 max. 10 35 - 45 min.
Food Quantity (kg) Oven setting Pre‐ heat‐ ing time (min) Grill posi‐ tion Grilling time (min) Total prepara‐ tion time (min) Shelf posi‐ tion Ribs 1.0 - 1.2 1/2 dis‐ tance 10 max. 40 - 50 40 - 501) 3 Burgers 2.0 - 2.5 1/2 dis‐ tance 10 max. 70 - 80 70 - 801) 3 Mackerel 1.2 - 1.5 1/2 dis‐ tance 10 max. 25 - 35 25 - 35 3 - 10 Toast Ha‐ wai 0.5 - 1.0 1) max. 15 - 20 15 - 20 3 1) Turn over after half of cooking time.
Do not loosen the screws. 1. Open the door fully. 3. Close the oven door to the first opening position (halfway). Then pull forward and remove the door from its seat. 2. Lift and turn the levers on the two hinges till they stop (until you reach the pins). Avoid placing the levers in the vertical position and make sure both of them are pulled maximally towards you. 4. Put the door on a soft cloth on a stable surface. 5. Use a screwdriver to remove the 2 screws from the bottom edge of the door. 1 1 6.
against the top edge of the door. Lift the inner door. 3 2 2 A 7. Clean the oven door with water and soap. Clean the inner side of the door. Dry the oven door carefully. When the cleaning is completed, install the glass panels and the oven door. To install the oven door, do the above steps in the opposite sequence. B Make sure the levers are in their original position before closing the door.
Troubleshooting WARNING! Refer to Safety chapters. What to do if... Problem Possible cause Remedy There is no spark when you try to activate the spark generator. The hob is not connected to an electrical supply or it is connec‐ ted incorrectly. Check if the hob is correctly connected to the electrical sup‐ ply. Refer to the connection dia‐ gram. There is no spark when you try to activate the spark generator. The fuse is blown. Make sure that the fuse is the cause of the malfunction.
Problem Possible cause It takes too long to cook the dishes or they cook too quickly. Remedy The temperature is too low or too high. Service data If you cannot find a solution to the problem yourself, contact your dealer or an Authorised Service Centre. Adjust the temperature if neces‐ sary. Follow the advice in the user manual. The necessary data for the service centre is on the rating plate. The rating plate is on the front frame of the oven cavity.
Other technical data Appliance category: II2H3B/P Gas original: G30 (3B/P) 28-30 mbar Gas replacement: G20 (2H) 20 mbar Bypass diameters BURNER Ø BYPASS 1/100 mm Auxiliary 29 / 30 Semi-rapid 32 Rapid 42 Triple Crown 67 Oven 54 Grill 59 Gas burners for NATURAL GAS G20 20 mbar BURNER NORMAL POWER kW REDUCED POWER kW INJECTOR MARK 1/100 mm Triple Crown 4.0 1.8 146 Rapid 3.0 0.72 119 Semi-rapid 2.0 0.43 96 Auxiliary 1.0 0.35 70 Oven 3.6 1.5 126 Grill 2.5 1.
Gas connection WARNING! Before you connect the gas, disconnect the appliance from the electricity supply or switch off the fuse in the fuse box. Close the primary valve of the gas supply. The gas pipe in the appliance has two endings. You can connect the gas supply to either one of them. The pipe that is not used must be clogged with the pipe closer, which added to the appliance. Use a fixed connections or use a flexible stainless steel pipes in compliance with the regulation in force.
B. Natural Gas pipe holder C. LPG pipe holder A Hob injectors replacement Replace the injectors when you change the gas type. 1. Remove the pan supports. 2. Remove the caps and crowns of the burner. 3. Remove the injectors with a socket spanner 7. 4. Replace injectors with the ones necessary for the type of gas you use. A Changing from natural gas to liquid gas 1. Fully tighten the bypass screw. 2. Put the knob back. Changing from liquid gas to natural gas 1.
2. Carefully remove from the burner the thermocouple A. Next remove the spark plug B. A B Adjusting the minimum gas level on the oven burner 1. Disconnect the appliance from the electricity. 2. Remove the knob for the oven functions. If there is no access to the bypass screw dismount the control panel before adjustment start. 3. With a thin and flat screwdriver adjust the bypass screw A. The model determines the position of the bypass screw A. A 3. Unscrew the screw and slowly pull out the burner.
10. Quickly turn the knob for the oven functions from maximum to the minimum gas flow position. Control the flame. Make sure the flame does not go out when you turn the knob to the minimum gas flow position. There must be a small regular flame on the oven burner crown. If the flame goes out adjust the oven burner again. 2. Disassemble the pan supports and all the burner assemblies. Gas grill injector replacement 1. Release the screws which keep the grill burner in position A. A 3.
To install all the accessories, do the first step in an opposite sequence. WARNING! The power cable must not touch the part of the appliance shaded in the illustration. Electrical installation WARNING! The manufacturer is not responsible if you do not follow the safety precautions from Safety chapters. This appliance is supplied with a main plug and a main cable. Environmental concerns appliances marked with the symbol with the household waste.
Made in Egypt 867342306-B-462018
