User's Manual

English
T1000 SERIES USER’S MANUAL
21
WARNING: Please pay attention to the following information about
keyboard maintenance.
1.Dust build-up may occur to the keyboard after long-term use.
It is recommended to clean the keyboard with a small brush.
Please shut down the machine before cleaning the surface of
the keyboard and wipe it with a soft cloth dipped in cleaner or
water gently.
2.In case any liquid enters the keyboard, shut off the power
supply immediately, remove the batteries and contact the
original manufacturer directly for repair. Do not disassemble the
keyboard yourself for repair.
Hard Disc Drive (HDD)
Trouble Solution
HDD can’t be
booted
The operating system is corrupted by incorrect
operation or virus. Try to clean virus and then
congure your operating system correctly.
Maybe the documents of your OS run in error;
please refer to the manual of your OS.
HDD performs very
slowly
There is too much le fragment. Use disk
defrag tools to rearrange the programs on the
hard disk.
WARNING: Please pay attention to the following information about
Hard Drive maintenance.
1.The hard disk is a high-speed data storage device. Avoid using
the T1000/T1005 in unstable locations as far as possible to
prevent hard disk damage and data loss.
2.Please use the computer in accordance with normal startup/
shutdown procedures; improper startup/shutdown may shorten
the service life of the hard disk.
Printer
Trouble Solution
The data can’t be
output from T1000/
T1005 to printer
Make sure printer is powered on.
Make sure its cable is OK and its USB interface
is well connected to T1000/T1005.
Make sure your printer is compatible to your
T1000/T1005.
Error printing
Please refer to the user’s manual of your
printer for help.
LAN
Trouble Solution
Can’t be connected
Be sure the RJ45 connector is rmly connected
to the Network Hub or Switch.
USB
Trouble Solution
Equipments
connected can’t
work
Check if the Netbook module name is T1000/
T1005M. The USB3.0 port (positioned at the
left side of T1000/T1005M) embedded with
T1000/T1005M can’t work under DOS mode.
Please connect the USB cord of the equipment
to other USB ports.
Be sure the driver of the equipment is installed
correctly.