User's Manual

13.56MHz
opular
ols.
jor
O14443
vices
ng
vided
ller
s
ending
oyalty,
erface
We welcome OEM inquiries
♦ Custom design manufacturing is available
♦ Custom device programming is available
♦ Call factory for other configuration
STREET,HSI
13.56MHz
RFID Multi-ISO Protocol
Reader
prot
d
oper
p
simultaneou
microcont
I
ithm
ds
200
ported
tle
k,
ESFire
LI
hout
8F.,NO.31, LANE 169, KANG-NING
STREET,HSI
-CHIH,TAIPEI,TAIWAN
TEL:
FAX:
e-
mail:
[e-mail]
[e-mail]
http://www.gigatms.com.tw
MP101A
Reader
alg
meth
su
conta
microcontroll
w
TEL:
886-2-26954214
FAX:
886-2-26954213
mail:
[e-mail]
[e-mail]
http://www.gigatms.com.tw
Federal Communication Commission Interference S
tatement
This equipment has been tested and found to comply with the limits for
a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one of the following measures:
. Reorient or relocate the receiving antenna.
. Increase the separation between the equipment and receiver.
. Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
. Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: To as
sure continued compliance, any changes or modifications not expressly
approved by the party responsible for compliance could void the user's authority to operate
this equipment. (Example - use only shielded interface cables when connecting to computer
or peripheral devices).
This device complies with P
art 15 of the FCC Rules. Operation is subject to the following
two conditions:
(1) This device may not cause harmful interference, and (2) This device must accept any
interference received, including interference that may cause undesired operation.