User's Manual

PWD100 User Guide

htt

://www.

atms.com.tw

Federal Communication Commission Interference Statement

This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a residential installation.

This equipment generates, uses and can radiate radio frequency energy and, if not

installed and used in accordance with the instructions, may cause harmful interference to

radio communications. However, there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and on, the user

is encouraged to try to correct the interference by one of the following measures:

. Reorient or relocate the receiving antenna.

. Increase the separation between the equipment and receiver.

. Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

. Consult the dealer or an experienced radio/TV technician for help.

FCC Caution: To assure continued compliance, any changes or modifications not

expressly approved by the party responsible for compliance could void the user's authority

to operate this equipment. (Example - use only shielded interface cables when connecting

to computer or peripheral devices).

FCC Radiation Exposure Statement

This

equipment complies with FCC RF radiation exposure limits set forth for an

uncontrolled environment.

This equipment should be installed and operated with a minimum distance of 20

centimeters between the radiator and your body.

This transmitter must not be co-located or operating in conjunction with any other antenna

or transmitter.

The antennas used for this transmitter must be installed to provide a separation distance

of at least 20 cm from all persons and must not be co-located or operating in conjunction

with any other antenna or transmitter.

This device complies with part 15 of the FCC rules. Operation is subject to the following

two conditions (1) This device may not cause harmful interference and (2) This device

must accept any interference received, including interference that may cause undesired

operation.